Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Topping up battery with DI water

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 98
Joined: Thu Sep 21, 2006 4:14 pm
Location: Jabiru

Topping up battery with DI water

Post by danos »

When topping up a battery with De-ionized water, how far do you fill them? My manual says do not overfill so i put enough in to just cover the cells.

Thanks
Top
Posts: 329
Joined: Tue Jun 28, 2005 3:08 pm
Location: Sydney

Re: Topping up battery with DI water

Post by Badass Bundy »

danos wrote:When topping up a battery with De-ionized water, how far do you fill them? My manual says do not overfill so i put enough in to just cover the cells.

Thanks
Yup just over the cells :)
80 Series 1HD-T
Front and Rear Factory Lockers
Rear drawer system with fridge slide
10,000Lbs Winch
Built for touring
Top
Posts: 98
Joined: Thu Sep 21, 2006 4:14 pm
Location: Jabiru

Post by danos »

Sweeeet!
Top
Posts: 572
Joined: Thu Mar 31, 2005 10:17 pm
Location: Mooroolbark Vic

Post by Jaffa »

Depending on the battery, if you look down into the cell your battery probably has a plastic "sleave" that goes down below the thread the cap screws into. Fill it to the bottom of the sleave, the plates should always be covered (even on angles etc)

Hope that make sense.

Brendan
Top
Posts: 898
Joined: Wed Nov 29, 2006 6:16 pm
Location: Melb S/E

Post by NutterGQ »

Jaffa wrote:Depending on the battery, if you look down into the cell your battery probably has a plastic "sleave" that goes down below the thread the cap screws into. Fill it to the bottom of the sleave, the plates should always be covered (even on angles etc)

Hope that make sense.

Brendan

Exactly how it should be done.
My bitch has boost, Nutter Engineering Turbo GQ
Top
Posts: 6021
Joined: Sat Feb 15, 2003 11:01 pm
Location: Shed.

Post by dumbdunce »

tip: don't waste your money on deionised water. the water from the tap is fine.
Free air locker to the first 20 callers!
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 145 guests