Hi all Im after a tail shaft spacer to connect between the diff and tail shaft. Has anyone had one made up for an NJ swb or that may fit an NJ. If so can I grab a number of you who made it for you.
Cheers
Glenn
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Im after a tail shaft spacer?
Moderator: -Scott-
i would say any local engineering shop would be able to make you one up. all they need is the outside dia and the pitch circle diameter of the bolt holes.
i would suggest that the holes in the spacer are made size for size to bolt dia and pitched in the dead centre of the spacer. this should keep the spacer nice and balanced.
make sure the longer bolts are high tensile grade 8.8 min.
probably easier to drop the shaft out and take it round there for them to measure up.
cookie monster
i would suggest that the holes in the spacer are made size for size to bolt dia and pitched in the dead centre of the spacer. this should keep the spacer nice and balanced.
make sure the longer bolts are high tensile grade 8.8 min.
probably easier to drop the shaft out and take it round there for them to measure up.
cookie monster
99 GU Patrol Wagon 4.2td
sounds logical, my mistake.J Top wrote:There is slightly more to a spacer as it needs to have a recess to locate the ring in the drive shaft flange and it needs the same ring to go into the diff flange. The bolts really are for clamping and the rings are for trueing the shaft
J Top
cookie monster
99 GU Patrol Wagon 4.2td
Bit of a rehash of an old thread here - but has anyone have any luck finding an off the shelf spacer since this post was first created?
Was looking at mine today to track down an oil leak which was coming from the output shaft seal and noticed how far out the prop shaft is sitting (approx 50mm). I do have access to the tools required to make one but would prefer an off the shelf item to save me the hassle.
As an afterthough - Does anyone know exactly how far the shaft of the sleeve yoke should fit into the extension housing of the transfer case?
Was looking at mine today to track down an oil leak which was coming from the output shaft seal and noticed how far out the prop shaft is sitting (approx 50mm). I do have access to the tools required to make one but would prefer an off the shelf item to save me the hassle.
As an afterthough - Does anyone know exactly how far the shaft of the sleeve yoke should fit into the extension housing of the transfer case?
When I read about the evils of drinking, I gave up reading
Who is online
Users browsing this forum: No registered users and 0 guests