Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
gq running bad ~ load it missfires
gq running bad ~ load it missfires
hi just havin a problem when i take off from a intersection in 1st gear or say put it into say 5th gear at like 50kms to create a load it missfires / breakes down and slightly jerks
its a gq / mav its doing it on gas its a carby model with extractors and snorkel
any suggestions would be great
thanks
its a gq / mav its doing it on gas its a carby model with extractors and snorkel
any suggestions would be great
thanks
Last edited by narns1mav on Fri Jan 18, 2008 5:41 pm, edited 1 time in total.
Plugs, points and leads will cause this as well as a bad tune of gas.
If its running too lean it will backfire though the carby
for a gas vehicle with points i recommend converting them to pointless ignition systems like a crane cam. simple, easy and they are optical sensor driven, no hall affect crap that i don't like
If its running too lean it will backfire though the carby
for a gas vehicle with points i recommend converting them to pointless ignition systems like a crane cam. simple, easy and they are optical sensor driven, no hall affect crap that i don't like
AA's for Quitters
Typically they run lean at high load low rpm, I change the secondary converter spring and retune to rectify it. Also electronic ignition on top of whats been mentioned, quality plugs, leads, cap, rotor.
The Petronix is OK as a points replacement but you can only run a points coil or one with high primary resistance, a HEI coil will burn it out due to the higher current draw. I fit an ICE module and coil raising the output from a potential 30 kV to 65 kV with over twice the burn time. The result is a noticable increase in power and low down torque with improved economy as well.
Joel
The Petronix is OK as a points replacement but you can only run a points coil or one with high primary resistance, a HEI coil will burn it out due to the higher current draw. I fit an ICE module and coil raising the output from a potential 30 kV to 65 kV with over twice the burn time. The result is a noticable increase in power and low down torque with improved economy as well.
Joel
-Pre trip inspections/ servicing
-Suspension/ custom modifications
-4wd Dyno & tuning
-Qualified mechanics
-Suspension/ custom modifications
-4wd Dyno & tuning
-Qualified mechanics
God of Magnificant Ideas!
Who is online
Users browsing this forum: No registered users and 1 guest