Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
getting ready for a swim
Moderator: Micka
getting ready for a swim
hey all finaly got my new rover nearly ready to got for a swim i need to finishe running breather but everything is easy ther my main problems are
1. snorkel how the hell do i fit one
its a 88 hiline with 3.5 i have a dual battery kit so i had move the vacume and power steer resovour
but when i put the filter back into position it doesnt fit, i cut the intake side of the filter an fitted a gutter pop in so its a wider intake an can attach a snorle easyer
has anyon got the same sort of set up ??
2, what do u do with the computer its under the seat an will be the first thing that get wet?
1. snorkel how the hell do i fit one
its a 88 hiline with 3.5 i have a dual battery kit so i had move the vacume and power steer resovour
but when i put the filter back into position it doesnt fit, i cut the intake side of the filter an fitted a gutter pop in so its a wider intake an can attach a snorle easyer
has anyon got the same sort of set up ??
2, what do u do with the computer its under the seat an will be the first thing that get wet?
5LTR Rangie
Ya dissy is the thing that will bring you unstuck. Pull the thing out and clean it up. Seal it with silicon anywhere water will get in,that means the cap as well. get the best plug leads you can.When driving in wet muddy stuff, mud gets on the leads ,so check them from time to time.Even take a rag to them to clean them if you have to. When you come across real deep stuff have clean leads and give them a spray with inox. Keep it clean and dry and it will run with water up to your screen..
smooth rides with power
hah yeah the dissy is allready done i am running comressed air into it about 3-4psi with new cap an plugs n sealant as well as well
yeah i ahev seen that plastic thing i wanna try stay away from that atm if possible worse case ill have to buy a new filter housing as mines allready modifyed
yeah i ahev seen that plastic thing i wanna try stay away from that atm if possible worse case ill have to buy a new filter housing as mines allready modifyed
5LTR Rangie
watch out for problems when feeding in compressed air. Did the same off the main tank and bingo, switched on the air one day prior to swimming via the solenid valve and the car stopped dead. Water in the line emptied straight into the dissy!! So will need to fit a water trap in that line before the dissy (there's one off the compressor, but not on the return lines from the tank)...
Nice gq swb ute chop with a huffer for the good times
swing
what i did was go to truckline and buy some 3 inch ruuber bend they have in stock grabed a pice of three in exhaut pipe and welde a cople o tabbs to hold it inplace coted insied with black enamal so it doent rust .then welded the mouning brackets to fit it too the n body then cover the ends of the rubber bends with cylicone and add a hose clamp on any join
i hope this helpsiff you want pick only happy to hepplp
cheers Dave
i hope this helpsiff you want pick only happy to hepplp
cheers Dave
Who is online
Users browsing this forum: No registered users and 1 guest