Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

WARN XD 9000 Installation???

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 52
Joined: Wed May 26, 2004 2:29 pm

WARN XD 9000 Installation???

Post by tbjaus2000 »

Can someone [please tell me if there is an INCORRECT Way of installing these.

IE i heard a rumour about the breaking system etc etc.

Does it matter which side the engage/disengage level and power connections are or not etc.????????
Top
Posts: 561
Joined: Tue Jan 04, 2005 2:25 pm
Location: Melbourne

Post by Cossie »

Cable should spool from the bottom of the drum, if not you may have to cut a new drain hole for the motor. Make sure the cables are on the correct terminals. Otherwise too easy.
The hardest thing about owning a jeep is telling your parents you're g a y!!
Top
User avatar
ddr
Posts: 589
Joined: Thu Jan 09, 2003 7:44 am
Location: Not where I wanna be

Post by ddr »

Whats the bar its going into?

If its the Nissan bar, it goes in upside down & needs a new drain hole on the motor housing.
Top
Posts: 130
Joined: Mon Jul 21, 2003 7:43 pm
Location: Gosford, NSW

Post by TOY-08V »

the cable MUST spool in the direction that is indicated by the sticker on the side of the drum housing and must pull in a straight line off the drum and thru the roller fairlead, so if u look thru the rollers when the winch is installed the cable should go straight to the drum.
AND i install winches and bullbars for a living and ive NEVER had to install one upside down as previously mentioned.
Top
Posts: 561
Joined: Tue Jan 04, 2005 2:25 pm
Location: Melbourne

Post by Cossie »

TOY-08V wrote:the cable MUST spool in the direction that is indicated by the sticker on the side of the drum housing and must pull in a straight line off the drum and thru the roller fairlead, so if u look thru the rollers when the winch is installed the cable should go straight to the drum.
AND i install winches and bullbars for a living and ive NEVER had to install one upside down as previously mentioned.
...Then you have NEVER put one in a genuine Nissan GU bar? :roll:

They go in upside down (gearbox on drivers side) and to prevent the motor filling with water, you cut a new drain slot in the motor side end housing.
The hardest thing about owning a jeep is telling your parents you're g a y!!
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 138 guests