Ive fitted some front recovery hooks on my 100 series, just wondering if using 4x high tensile washers as spacers is putting extra strain on the bolts and creating weak points or could i get away with it?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
100 series recovery hooks - is this dodgy ?
Moderators: toaddog, Elmo, DUDELUX
100 series recovery hooks - is this dodgy ?
hey guys just looking for some opinions,
Ive fitted some front recovery hooks on my 100 series, just wondering if using 4x high tensile washers as spacers is putting extra strain on the bolts and creating weak points or could i get away with it?
Ive fitted some front recovery hooks on my 100 series, just wondering if using 4x high tensile washers as spacers is putting extra strain on the bolts and creating weak points or could i get away with it?
Re: 100 series recovery hooks - is this dodgy ?
If it's all pulled up tight and even and flat I can't see any real issues Matty. If you are uncomfortable though get a small bit of 5mm,by the looks, flat plate and drill a hole in it. It might only be in side loading if there were any that the washers might not be the best, like if you were recovered on a bit of an angle in theory the mount could twist a bit at that point where you don't have full coverage underneath but it wouldn't be much. Me though I'd still prefer a bit of plate.matty00 wrote:hey guys just looking for some opinions,
Ive fitted some front recovery hooks on my 100 series, just wondering if using 4x high tensile washers as spacers is putting extra strain on the bolts and creating weak points or could i get away with it?
Side note I was goign to make some fo these for me and some mates possibly. Any chance you could give me an idea on size to compare to what I was going to do. Most importantly thickness or material but also width of plate where it bolts to chassis and how long/wide the actual recovery hook section is. Also size of hole would be handy.
Who is online
Users browsing this forum: No registered users and 4 guests