Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Calmini suspension lean
Calmini suspension lean
95 !.6 lwb vitara , what would be a normal suspension lean for the calmini suspension?
Ive noticed that they all lean to the right to a point.
Ive noticed that they all lean to the right to a point.
93 NJ,5 speed,2" body lift,32" muddies
There's nuttn like momentum
There's nuttn like momentum
its more to do with the engine torquing, fuel tank, driver, battery etc all being on that side of the zuk... its more common in sierras than vitaras but generally its because of that extra weight and the manufacturers dont account for it - or in calmini's case the driver is usually on the other side so it prolly balances out =)
The worst thing about censorship is ███████.
What lean? Mine has always been within a few mm either side on a 1.6 lwb, 1.6 swb and 2.0 swb although the 2.0 swb is running different front springs. The Calmini front springs are not that great and can sag so maybe yours has sagged on one side only.
[quote="4WD Stuff"]
I haven't quoted Grimbo because nobody takes him seriously :finger: :finger: :finger: :finger: [/quote]
I haven't quoted Grimbo because nobody takes him seriously :finger: :finger: :finger: :finger: [/quote]
After I fitted the Calmini lift to mine it had a lean to the right, used to annoy me no end.
So I fitted a 1 1/2" spring spacer to the right rear to balance it out.
So I fitted a 1 1/2" spring spacer to the right rear to balance it out.
Suzuki Vitara JX 1.6 EFI Hardtop.
Calmini Lift, Rockhopper, Skid Plates, ARB Airlocker, Bullbar, 30" MTR, Custom Sill Sliders, Rear Bar.
See my pics
http://community.webshots.com/user/suzukiboyoz
Calmini Lift, Rockhopper, Skid Plates, ARB Airlocker, Bullbar, 30" MTR, Custom Sill Sliders, Rear Bar.
See my pics
http://community.webshots.com/user/suzukiboyoz
Tried swaping springs still had the same lean.scooby_74 wrote:This one has 15mm lean to right, was thinking of a 10mm spacer under the right rear coil.
That and or swaping rear coils left to right.
Go a spring spacer, there is a guy in the England that sells them, much better design then I have seen over here.
See if I can find this ebay pages.
Suzuki Vitara JX 1.6 EFI Hardtop.
Calmini Lift, Rockhopper, Skid Plates, ARB Airlocker, Bullbar, 30" MTR, Custom Sill Sliders, Rear Bar.
See my pics
http://community.webshots.com/user/suzukiboyoz
Calmini Lift, Rockhopper, Skid Plates, ARB Airlocker, Bullbar, 30" MTR, Custom Sill Sliders, Rear Bar.
See my pics
http://community.webshots.com/user/suzukiboyoz
Also my spring spacer is on the top.
scooby_74 too bad you are not in Brisbane, because I was going to buy a set off him I know someone else that only wants one as well.
Here is the link the the spacers.
I now see he sells them in a set of two or four, good to have a spare, not that mine has failed yet.
http://cgi.ebay.co.uk/Suzuki-Vitara-Gra ... dZViewItem
scooby_74 too bad you are not in Brisbane, because I was going to buy a set off him I know someone else that only wants one as well.
Here is the link the the spacers.
I now see he sells them in a set of two or four, good to have a spare, not that mine has failed yet.
http://cgi.ebay.co.uk/Suzuki-Vitara-Gra ... dZViewItem
Suzuki Vitara JX 1.6 EFI Hardtop.
Calmini Lift, Rockhopper, Skid Plates, ARB Airlocker, Bullbar, 30" MTR, Custom Sill Sliders, Rear Bar.
See my pics
http://community.webshots.com/user/suzukiboyoz
Calmini Lift, Rockhopper, Skid Plates, ARB Airlocker, Bullbar, 30" MTR, Custom Sill Sliders, Rear Bar.
See my pics
http://community.webshots.com/user/suzukiboyoz
Not a vitara I know but my sierra with calmini lift leans, as mentioned I think it has more to do with weight. I put the spare on the passenger side to help combat it and I plan to do some more weight shifting soon.
Build Thread - http://www.outerlimits4x4.com/viewtopic.php?f=16&t=168546&p=1927514&hilit=GRPABT1%27s+zook#p1927514
Who is online
Users browsing this forum: No registered users and 1 guest