Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

front windows 96 disco

Tech Talk for Rover owners.

Moderator: Micka

Post Reply
Posts: 14
Joined: Mon May 02, 2005 6:41 pm
Location: townsville

front windows 96 disco

Post by ottie »

my front left window will not work.ive tried two motors that work still no joy.ive got power going to the motor,ive got power at the switch.ive swapped the switches over, ive put the drivers plug on it and still no joy.the drivers side works fine and the motors work on that side to.ive checked the fuses, all good.is there a solenoid for each window?if so which one.its doing my head in :twisted:
MUD RAT
DL
Posts: 299
Joined: Wed May 31, 2006 8:33 pm
Location: Bellarine, Brackistan

Post by DL »

Hi Ottie,

Link below is free complete 96 Disco w/shop manual. Should have all the info you need, and then some.

You will need to be on broadband because it's a 14 M pdf. (big file)

http://www.landrover.ee/est/files/manua ... 5-1996.pdf

cheers, DL
Posts: 2691
Joined: Sun Sep 03, 2006 7:31 pm
Location: where ever the track takes me

Post by muddydigger »

Check the maechanial mechanisum sounds like its jammed, I dont think you have an electrical fault
For Kart racing information please visit our site at www.auskart.net
Posts: 14
Joined: Mon May 02, 2005 6:41 pm
Location: townsville

Post by ottie »

but the motor wont work when its plugged in and not connected to the window mech but will work when i do the same on the drivers door.. :x
MUD RAT
Posts: 1057
Joined: Mon Feb 10, 2003 12:28 pm
Location: Eastern Sector

Post by mickrangie »

chk the solder joints on the window lift ecu (behind glove box) its very common for them to become dry joints so you wont be getting any power

HTH

Mick
TD5 96 Discovery UTE.
Posts: 14
Joined: Mon May 02, 2005 6:41 pm
Location: townsville

Post by ottie »

ill try that tomorrow.thanks.but would this be the case as when i use the test light it lights up at the plug and after the plug before the motor?
MUD RAT
Posts: 1057
Joined: Mon Feb 10, 2003 12:28 pm
Location: Eastern Sector

Post by mickrangie »

ottie wrote:ill try that tomorrow.thanks.but would this be the case as when i use the test light it lights up at the plug and after the plug before the motor?
maybe it might be earth, signal and power i am not 100%
TD5 96 Discovery UTE.
Posts: 176
Joined: Sat Jun 16, 2007 8:18 am
Location: New Zealand

Post by bigbad »

might be enough current to light the test lamp but not run the motor, I have a cheap ECU if you need one.
Posts: 14
Joined: Mon May 02, 2005 6:41 pm
Location: townsville

Post by ottie »

thanks to all :) it was a bad solder. :D
MUD RAT
Post Reply

Who is online

Users browsing this forum: No registered users and 28 guests