12mm Control arm spacer

[wormz14]

I just orded some new coils, shocks and bushes for my patrol with 75mm lift, so while i have it apart i want to fit some 12mm spacer to the front control arms to make way for some bigger rubber later on ,Dose anyone have any spec's on how to make them, also what the best thing to make them out of.

[chunderlicious]

dude, they cost 60 bucks from superior..... but if you that tight

a bit of 12mm plate and a bit of tube that is the same diameter as the rear thread. they are a real simple idea but if you dont have a laser/water/jet cutter itll be more expensive to make ur own.

[wormz14]

I didnt think any one made them but for that money i aint gunna bother messen around i will order some tomrrow, thanks for the tip.

[gusto]

the larger washer needs to have 45mmOD-24mmID and the smaller washer 24mmOD-16mmID

both the same thickness obviously

cheers

OONDY

If you know someone with access to a lathe it's a 10-15min job