Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

12mm Control arm spacer

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 28
Joined: Fri Aug 17, 2007 8:40 am
Location: never far away

12mm Control arm spacer

Post by wormz14 »

I just orded some new coils, shocks and bushes for my patrol with 75mm lift, so while i have it apart i want to fit some 12mm spacer to the front control arms to make way for some bigger rubber later on ,Dose anyone have any spec's on how to make them, also what the best thing to make them out of.
Posts: 2601
Joined: Tue Jul 13, 2004 8:02 pm
Location: warner, brisbane

Post by chunderlicious »

dude, they cost 60 bucks from superior..... but if you that tight :finger:

a bit of 12mm plate and a bit of tube that is the same diameter as the rear thread. they are a real simple idea but if you dont have a laser/water/jet cutter itll be more expensive to make ur own.
turbos are nice but i'd rather be blown
Posts: 28
Joined: Fri Aug 17, 2007 8:40 am
Location: never far away

Post by wormz14 »

I didnt think any one made them but for that money i aint gunna bother messen around i will order some tomrrow, thanks for the tip.
Posts: 18
Joined: Fri Apr 11, 2008 9:44 pm
Location: Mackay

Post by gusto »

oondy wrote:the larger washer needs to have 45mmOD-24mmID and the smaller washer 24mmOD-16mmID

both the same thickness obviously

cheers

OONDY
If you know someone with access to a lathe it's a 10-15min job
Post Reply

Who is online

Users browsing this forum: No registered users and 82 guests