Dual transfer case setup

[Wolverine]

G'day all,

i have just purchased three lj50's (all pretty rough!!!) for $450 and going to try and create something cool out of them.
I know the lj50 transfercases are pretty low geared but would they be enough to run 33"s off road.
One of the lj's has a 4k engine in it so I will be running that till it dies!!!!!!!
If the gearing is not low enough for some cool rockcrawling then I was going to try and put two transfercases in.
My question then is can one be bolted straight onto the rear of the other or should I run a shaft/double cardin joint between them.

Any suggestions.

cheers

[christover1]

any two things bolted together must be very straight and true, or ya get vibrations. less need to be exact if you run some sort of jointed shaft. even a single rubber uni may help, but two on a shaft is best, christover. PS, have not done this, just learned by others mistakes, etc

[bigsteve]

I could be wrong but I remember hearing that the LJ cases were quite small i.e. too small, but I could be wrong.

I'm sure Greg would be interested in an LJ body though.