i think all this is overkill engineering..
i was at a local wrecker today and looked at a FORD ef wagon.. the rear shackle is held onto the chassic by TWO 8mm bolts on each side. i was horrified when i saw that.
im sure joe has used/ sold and tested his arm with no complaints. im a little worried about the lower tie rod mt where the plate kicks out with no bracing, im sure the load of steering would not be good at that point, but as i say its tried and tested
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
another spoa question
Joe, does this still use bolts to hod it in, is there any option or point to upgrading to stud\cone washer style setup to add a bit of extra beef ?joeblow wrote:this one just relocates the drag link.and this sort of stuff has to be x-ray tested.
and don't use 2 inch springs with a spring over.use your current leaves and add an old man emu xl to each pack.
" If governments are involved in the covering up the knowledge of aliens, Then they are doing a much better job of it than they do of everything else "
standard leafs that are flat, 2" BL taken out since that pic was taken so it sits lower, yes its a NT and its not as bad as turbo tonka and aerenandmel say, but yes it is high id say now about 5-6" lift without BL
It really isnt that high, no lift blocks just SPOA standard leafs that are sagged and 2" shackles witch are commin out next week.
It really isnt that high, no lift blocks just SPOA standard leafs that are sagged and 2" shackles witch are commin out next week.
Bear in mind the rear shackle mount on a car takes almost no load. (really) that's why whacky shackles and 3/4 eliptic can work.11_evl wrote:i think all this is overkill engineering..
i was at a local wrecker today and looked at a FORD ef wagon.. the rear shackle is held onto the chassic by TWO 8mm bolts on each side. i was horrified when i saw that.
im sure joe has used/ sold and tested his arm with no complaints. im a little worried about the lower tie rod mt where the plate kicks out with no bracing, im sure the load of steering would not be good at that point, but as i say its tried and tested
I agree -I'm sure this arm does work but also agree about the gusseting and that cone washers and/or dowels would be an improvement.
I have two histeer arms at home that I pulled off cars I put back to SPUA and they are both scary and neither would be anywhere near as strong as Joes design.
Steve.
[quote="greg"] some say he is a man without happy dreams, or that he sees silver linings on clouds and wonders why they are not platinum... all we know, is he's called the stevie.[/quote]
Who is online
Users browsing this forum: No registered users and 0 guests