Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

ls1 rear main seal replacement info needed

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 2298
Joined: Sat Jun 11, 2005 11:26 pm
Location: nsw maitland

Contact:
Contact cooter

ls1 rear main seal replacement info needed

Post by cooter »

just wondering if ay1 has a manual i can have a look at mate of mine is replacing his this week and needs to know a bit about the job before he tackles it and also need tensions for flex plate
http://www.4wdaction.com.au/shed/index.php?id=1097&im=1
[quote="squik"]He He... every time I turn off my protection my box gets slammed with spam....
[/quote]
Top
Posts: 139
Joined: Wed Jun 18, 2008 7:51 pm
Location: NSW

Post by highwaychook »

I have a thread about this in Toyo tech. ;)
Top
Posts: 2298
Joined: Sat Jun 11, 2005 11:26 pm
Location: nsw maitland

Contact:
Contact cooter

Post by cooter »

im after info on the chev alloy 350 not sure whether it is a 1 piece seal or not
http://www.4wdaction.com.au/shed/index.php?id=1097&im=1
[quote="squik"]He He... every time I turn off my protection my box gets slammed with spam....
[/quote]
Top
Posts: 533
Joined: Sat Jan 15, 2005 4:54 pm
Location: Melbourne, Australia.

Contact:
Contact InSanE

Post by InSanE »

I am a mech at a Holden dealer mate and the the flywheel/flexplate bolts are tentioned at 100nm and they are consumable bolts and must be replaces with new ones, and the pressure plate bolt torque is 70nm just make sure you locktite the flywheel/flexplate bolts and the clutch plate bolts as I have seen a few come loose in my time.

Also yea it is a one peice seal but they have a plate on the rear of the motor that can leak Its not very common but wouldnt hurt to change that while your there its upto you mate.
GQ LWB TD42, boost, lockers etc

http://forum.mudrhino.com.au/viewtopic.php?t=262&start=30
Top
Posts: 2134
Joined: Tue May 11, 2004 6:03 pm
Location: Armidale

Post by BOGAN V8 »

i have a manual here that covers that if ya want i can scan a few pages and email it to ya...
94 HJZ 80 GXL 4 Inch lift 35s. TJM Accessories Front to back
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 2 guests