But, There is no evidence of any of this happening!! Could somebody PLEASE measure their input shaft, so I can clarify it is or isn’t my shaft?? Thanks heaps!!!
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
shaft issues!!??
shaft issues!!??
Hey peoples.. the input shaft in my 91 WT sierra (the shaft from the gearbox, to the transfer) is only riding on half of the spline Within the gearbox. Its as though either A) The shaft has been shortened, B) the motor has been moved forward, or C) the transfer has been moved back.
But, There is no evidence of any of this happening!! Could somebody PLEASE measure their input shaft, so I can clarify it is or isn’t my shaft?? Thanks heaps!!!
But, There is no evidence of any of this happening!! Could somebody PLEASE measure their input shaft, so I can clarify it is or isn’t my shaft?? Thanks heaps!!!
F&R ARB air lockers, lux diffs, 4 link coil rear, drop shackles, inboarded ranchos, stage 4 reduction gears, 35" silverstones, 9500 winch, RUF, 1.6 EFI, swimming goggles
It called a "Jackshaft" for future reference.
Measured 2, and both are approximetly 245mm-250mm from pin to pin. (That is from the centre pin of one universal to the other universal). both are from '91, '92 WT SWB Sierra softop.
I was working in pretty poor light, so could not be too precise. Not really sure how much spline should be exposed either...
Hope that helps
Measured 2, and both are approximetly 245mm-250mm from pin to pin. (That is from the centre pin of one universal to the other universal). both are from '91, '92 WT SWB Sierra softop.
I was working in pretty poor light, so could not be too precise. Not really sure how much spline should be exposed either...
Hope that helps
Wheeling on completely wicked angles, without even looking stable.
Re: shaft issues!!??
hahahahahaget it up there wrote:Could somebody PLEASE measure their input shaft, so I can clarify it is or isn’t my shaft?? Thanks heaps!!!
1994 Sierra for Sale - Check the For Sale Section
Who is online
Users browsing this forum: No registered users and 74 guests