Hi, I have a 1985 SWB patrol. The locking hubs are leaking. I have an 83 patrol that I pulled the motor out of where I can get another set from. Would it be easier to swap the hubs or just do the entire axle? Would there be any difference between the two models in this area?
Cheers,
Marz
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Swapping locking hubs or entire axel?
As dansedgli said!
The hubs could possibly bolt on BUT there should be no oil in there to
leak out! Only grease. Most likely your axle seals are stuffed letting the diff oil out into the knuckle area. getting mixed with the grease in there
and then leaking out. Typically they leak out from the knuckle wiper seal area not at the locking hubs. check the bolts might be loose!
cheers
The hubs could possibly bolt on BUT there should be no oil in there to
leak out! Only grease. Most likely your axle seals are stuffed letting the diff oil out into the knuckle area. getting mixed with the grease in there
and then leaking out. Typically they leak out from the knuckle wiper seal area not at the locking hubs. check the bolts might be loose!
cheers
JB
Who is online
Users browsing this forum: No registered users and 1 guest