Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

commodore v6/auto in a lux how do they go ?

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Post Reply
Posts: 237
Joined: Tue Dec 20, 2005 9:23 pm
Location: Rosebud vic

commodore v6/auto in a lux how do they go ?

Post by juzzydykes75 »

lookin at various engine options for a hilux and although id love the gen 3 for a budget ive noticed that a lot of people are putting commodore v6's and autos in the older luxes - just wondering how they go with larger tyres etc - prob look at stepping up to 35/36's in the future so wouldnt want to waste my money on a motor transplant option that wont turn em or runs too fast for slow crawling.
Im building a project 84 dual cab lux
1991 Hdj80 ,
Posts: 2347
Joined: Sat Jan 27, 2007 12:56 pm
Location: Perth

Post by Z()LTAN »

the buick commodore v6 is easy to keep cool, cheap, light and fairly powerful.

With the right ratio combinations and tyre sizes you can make it how u want.

Rekit the trans b4 u put it in as the commodore slushbox is the first thing to go...

Ive seen full conversions done properly for 2k...
Locktup4x4.com.au - For all of your hardcore gear

Outlaws4x4.com
Posts: 237
Joined: Tue Dec 20, 2005 9:23 pm
Location: Rosebud vic

Post by juzzydykes75 »

cool thanks , just tryin to get ideas - would really love the gen3 but the missus has hold of the wallet. and i have a vp v6 and auto in the shed
1991 Hdj80 ,
Posts: 82
Joined: Sun Jun 04, 2006 5:12 pm
Location: Illawarra, NSW

Post by BEU77y »

I know a local guy with a Commo V6 set up in his Lux. I think he has dramas with rear diffs... but that might have something to do with he right foot....
One of his mates had a 5L in a dual Lux but it was thirsty and spent most of it's time on Stokton cooling down.
Posts: 172
Joined: Thu Aug 09, 2007 7:03 pm
Location: Torbanlea QLD

Post by Burdy »

i had the v6 commo setup in my old lux running the standard G52 five speed gearbox i went threw 3 gearboxs and 1 diff but it depends on how u drive i was towing a fair bit of weight with mine. they are thirsty on fuel mine used about 17litres per 100kms
if i was going to do the conversion again i'd run 4.88 diff gears to run 35's and reduction gears in the transfer
MUD BEERS & MAYHEM 4x4 and SOCIAL Group
5 inch lift,33 MTZ's,240 XGT's,3 inch dump & exhaust and more to come
Posts: 1650
Joined: Wed Jun 06, 2007 10:12 pm
Location: ipswich

Post by sloshy »

Cheaper going 3rz and way easier, no adaptors :twisted:
cheers Dan

Licenced Carpenter
I do everything, free quotes
Brisbane west/Ipswich/rural
PM me
Posts: 750
Joined: Mon Aug 25, 2008 12:06 am
Location: gold coast

Post by johnsy86 »

yeah go 3rz its designed for off and on road , not a v6 thats designed to push a commodor at 100km along the highway.
Posts: 139
Joined: Sun Jan 20, 2008 8:59 pm
Location: Brisbane

Post by Ryan_006 »

If your considering the v6 id go a step further and look at the 304 5.0L. Same fuel economy from what i can tell, and the 304 will make a lot more low down torque.
Ive just gone from 308 on gas to 304 injected in my 86 single cab and so far i am getting 16 litres/100km, stays cool all the time even with these stinkin hot days we are having. Picked the motor up for $1650 with everything you need.
Also if your looking at autos the gearing will pose a problem for you as it did for me, the autos tend to want to run away from you down hill which is frickin scary as, reduced gearing in the transfer solved that for me.

I think it depends on your budget, im sure you will see a lot of guys on here have lots of success with the 3rzfe motors too, they are bullet proof motors and are not too expensive to do either. Doing the v8 is always going to add a fair bit more cost onto your project

Cheers
Posts: 810
Joined: Thu Jul 15, 2004 8:02 am
Location: Somewhere in NSW

Post by brighty »

Just a quick question.... what motors are the 3rz & 3rzfe out of and whats the difference.... I'm guessing a later model hilux and turbo/non turbo??? And these would be a 3ltr engine??? Just guessin though!! :roll:

Mate of mine has an 85 4runner and looking at doing a conversion somewhere down the track, so still considering options atm. Cheaper and easier the better.... but anythings got to be better than the old 2.4 deisel in it now!!!
When in doubt..... UTE-ERIZE it!!!
Posts: 1574
Joined: Tue Mar 21, 2006 7:34 am
Location: Greenbank - Home of the web wheelers

Post by booflux »

brighty wrote:Just a quick question.... what motors are the 3rz & 3rzfe out of and whats the difference.... I'm guessing a later model hilux and turbo/non turbo??? And these would be a 3ltr engine??? Just guessin though!! :roll:

Mate of mine has an 85 4runner and looking at doing a conversion somewhere down the track, so still considering options atm. Cheaper and easier the better.... but anythings got to be better than the old 2.4 deisel in it now!!!
3RZ is what people shorten it to 3RZ-FE is the full engine code like a 1UZ is a 1UZ-FE etc.

They are a 2.7 twin cam efi 4cyl petrol. They came in Hiluxs both 2wd and 4wd from late 97 on. They changed to a different efi system around 02 and I believe to VVTI from around 05. They are a great motor and as said above a very cheap conversion, Id put one in before a commo 6 everytime.
Toy: 98 TJ with some mods and some bling
Tourer and daily: 120 Prado with some mods
Posts: 105
Joined: Sun Nov 18, 2007 7:12 pm
Location: Dont no

Post by msjc38 »

2 grand to do a v6
I did mine but dont have it anymore it cost 6 grand in parts but it was a mint conversion they go well but dont use the origanal 5 spd
Posts: 70
Joined: Tue Jan 15, 2008 10:42 am
Location: Ballarat

Post by LFONZ »

Ryan_006 wrote:If your considering the v6 id go a step further and look at the 304 5.0L. Same fuel economy from what i can tell, and the 304 will make a lot more low down torque.
Ive just gone from 308 on gas to 304 injected in my 86 single cab and so far i am getting 16 litres/100km, stays cool all the time even with these stinkin hot days we are having. Picked the motor up for $1650 with everything you need.
Also if your looking at autos the gearing will pose a problem for you as it did for me, the autos tend to want to run away from you down hill which is frickin scary as, reduced gearing in the transfer solved that for me.

I think it depends on your budget, im sure you will see a lot of guys on here have lots of success with the 3rzfe motors too, they are bullet proof motors and are not too expensive to do either. Doing the v8 is always going to add a fair bit more cost onto your project

Cheers
I've got the 304 injected as well. Thursty damn yes, forgot to add the speed sensor, 25-30 ltrs per 100kms and yes i no that is way to much, but that what it is doing (untill i fix the f#$ker).
Conversion kit $$$ are damn close wether or not is V6 or V8, the only diff i found was the engine. V6 would give you more engine bay room.
"Built by toyota, Powered by HOLD-ON"
98' single cab hilux, 5.0ltr EFI holden V8
Posts: 1255
Joined: Thu Jul 03, 2003 8:07 pm
Location: Coffs Harbour

Post by STUMPY »

booflux wrote:
brighty wrote:Just a quick question.... what motors are the 3rz & 3rzfe out of and whats the difference.... I'm guessing a later model hilux and turbo/non turbo??? And these would be a 3ltr engine??? Just guessin though!! :roll:

Mate of mine has an 85 4runner and looking at doing a conversion somewhere down the track, so still considering options atm. Cheaper and easier the better.... but anythings got to be better than the old 2.4 deisel in it now!!!
3RZ is what people shorten it to 3RZ-FE is the full engine code like a 1UZ is a 1UZ-FE etc.

They are a 2.7 twin cam efi 4cyl petrol. They came in Hiluxs both 2wd and 4wd from late 97 on. They changed to a different efi system around 02 and I believe to VVTI from around 05. They are a great motor and as said above a very cheap conversion, Id put one in before a commo 6 everytime.
Second that. They are a good strong motor that can handle some boost as well :D
DX80 35's twin locked turbo diesel = TANG
www.jaybeecanvas.com
pom
Posts: 285
Joined: Tue Mar 25, 2008 7:05 pm
Location: maitland, nsw

Post by pom »

ive got a v6 in mine 4.8 ratios and dual cases and it works great except over heats and blows cv's like they are paddle pops lol other than that awesome for the price range and a v8 would just cause more dramas with braking running gear... ill let you no when its goin good and got 42's running gear mite not cope to good :?
SCUM LUX 09!
Any fab work of any form including tig give me a yell! 0431718878.
Posts: 1650
Joined: Wed Jun 06, 2007 10:12 pm
Location: ipswich

Post by sloshy »

pom wrote: works great except over heats
Just what a slow 4wd needs :?
cheers Dan

Licenced Carpenter
I do everything, free quotes
Brisbane west/Ipswich/rural
PM me
Posts: 1022
Joined: Tue Oct 09, 2007 6:29 pm
Location: geelong

Post by AcTioN13 »

there are ways to sort out over heating, just costs more trial end error
Posts: 105
Joined: Sun Nov 18, 2007 7:12 pm
Location: Dont no

Post by msjc38 »

marks adaptors have engine driven fans for them they work well but noisy
Posts: 1022
Joined: Tue Oct 09, 2007 6:29 pm
Location: geelong

Post by AcTioN13 »

can also get larger radiators, when ute comes back from getting auto rebuilt, will be testing a 50mm thick all alloy commie radiator with a 16" thermo with shroud.

there aint much room in the engine bay now
Posts: 139
Joined: Sun Jan 20, 2008 8:59 pm
Location: Brisbane

Post by Ryan_006 »

My 304 has zero heating issues running a standard hilux sized alloy rad and twin 8 inch thermos on the front side(lack of engine bay room), would probably work equally as good on the v6
Ln65 single cab
Posts: 172
Joined: Thu Aug 09, 2007 7:03 pm
Location: Torbanlea QLD

Post by Burdy »

pom wrote:ive got a v6 in mine 4.8 ratios and dual cases and it works great except over heats and blows cv's like they are paddle pops lol other than that awesome for the price range and a v8 would just cause more dramas with braking running gear... ill let you no when its goin good and got 42's running gear mite not cope to good :?

I ran the standard hilux diesel radiator in mine with a vs v6 thermo fan and had no overheating issues
MUD BEERS & MAYHEM 4x4 and SOCIAL Group
5 inch lift,33 MTZ's,240 XGT's,3 inch dump & exhaust and more to come
pom
Posts: 285
Joined: Tue Mar 25, 2008 7:05 pm
Location: maitland, nsw

Post by pom »

yer im gettin the same a bigger alloy radiator and dual thermos and ill see how that goes my power steering fluid boils too :roll:
SCUM LUX 09!
Any fab work of any form including tig give me a yell! 0431718878.
Posts: 1022
Joined: Tue Oct 09, 2007 6:29 pm
Location: geelong

Post by AcTioN13 »

and if you go the auto, be gentle, and make sure you fit a breather to it if you go any where near water.

lesson learned
pom
Posts: 285
Joined: Tue Mar 25, 2008 7:05 pm
Location: maitland, nsw

Post by pom »

yer ive gone the auto and it hasnt worked proply from day one so im puttin a new one in and see how it goes seems ok out bush as in the respects of easier to drive
SCUM LUX 09!
Any fab work of any form including tig give me a yell! 0431718878.
Post Reply

Who is online

Users browsing this forum: No registered users and 128 guests