Changeing cv shafts pajero

[siggie]

gidday guys Im wondering if this is easy enough to do at home and if any special tools are required.

[short stuff]

if you have an air compressor and those inner and outer pliers,a jack and a spare set hands your good i just finished mine

[redreid1978]

very easy job , take the locking cap of the outer wheel ( six 10mm ) bolts and and remove the sirclip , then undo the cv from the axle centre , slide the end from the axle out first , it is easyer if un done have the front smash tray in.. then once u slide it out front the axle end its done.. easy as that put new one in , and aslso since u have the cap off tighten the bearings , remove second stage of outer cap ... wipe out grease ,, then there is 2 x head screws remove them and the retainer .. tighton bearing firm and then regrease and put back together...

[siggie]

Thanks guys
doing job early next week
siggie

[pom300]

i had to undo the top balljoint when i did mine it just was to long to pull out
i needed that little bit of extra room amd it made it easier putting them in aswell. good luck