Hey all,
Just want to get other peoples opinions on the narva or hella 4pin relays that have the blade fuse built into them. I have always seen them, but have never really used them. I took one apart today and they look OK quality.
Only prob is they are not suppresed, Which means would have to add an external suppression diode.
Anyway, does anyone use them and what do you think about them?
Steve
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Fused relay's opinions
Moderator: -Scott-
Fused relay's opinions
KILLA KUSTOM KABLES
CUSTOM AUTO ELECTRICAL SPECIALISTS
0404811498
LS1 & DURAMAX ENGINE CONVERSIONS, DRIVE IN DRIVE OUT. PATROLS AND CRUISERS
LS1 STANDALONE HARNESS $475ex
CUSTOM AUTO ELECTRICAL SPECIALISTS
0404811498
LS1 & DURAMAX ENGINE CONVERSIONS, DRIVE IN DRIVE OUT. PATROLS AND CRUISERS
LS1 STANDALONE HARNESS $475ex
I always like to put the fuse as close to the power source as possible (which is usually the battery +ve terminal when using relays.) So I can't see much point in them personally.
Unless you're driving the relay coil from some sort of electronic triggering circuit the suppression diode shouldn't really be necessary?
Unless you're driving the relay coil from some sort of electronic triggering circuit the suppression diode shouldn't really be necessary?
David
Most electronics interfaces with the relays (ECU's etc) will have the diode on the circuit board rather than near the relay. Very few relays are produced with the flyback diode on the base.
George Carlin, an American Comedian said; "Think of how stupid the average person is, and realise that half of them are stupider than that".
Who is online
Users browsing this forum: No registered users and 3 guests