Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Fused relay's opinions

For all things Electrical.

Moderator: -Scott-

Post Reply
Posts: 1208
Joined: Fri Nov 08, 2002 8:21 pm
Location: sunshine coast

Fused relay's opinions

Post by killalux »

Hey all,

Just want to get other peoples opinions on the narva or hella 4pin relays that have the blade fuse built into them. I have always seen them, but have never really used them. I took one apart today and they look OK quality.
Only prob is they are not suppresed, Which means would have to add an external suppression diode.

Anyway, does anyone use them and what do you think about them?

Steve
KILLA KUSTOM KABLES
CUSTOM AUTO ELECTRICAL SPECIALISTS
0404811498
LS1 & DURAMAX ENGINE CONVERSIONS, DRIVE IN DRIVE OUT. PATROLS AND CRUISERS

LS1 STANDALONE HARNESS $475ex
Posts: 4760
Joined: Mon Dec 30, 2002 6:04 am
Location: Adelaide

Post by murcod »

I always like to put the fuse as close to the power source as possible (which is usually the battery +ve terminal when using relays.) So I can't see much point in them personally.

Unless you're driving the relay coil from some sort of electronic triggering circuit the suppression diode shouldn't really be necessary?
David
God of Athiests
Posts: 8336
Joined: Thu Aug 07, 2003 2:14 am
Location: Brownsville

Post by DamTriton »

Most electronics interfaces with the relays (ECU's etc) will have the diode on the circuit board rather than near the relay. Very few relays are produced with the flyback diode on the base.
George Carlin, an American Comedian said; "Think of how stupid the average person is, and realise that half of them are stupider than that".
Posts: 1094
Joined: Tue Feb 10, 2004 6:58 pm

Post by STIKA »

I have had no dramas with them

This is the set up i use

Image

Relay and fuse is directly below the switch they control
Supported By
Milanco
Phones N Alarms
Buds Customs
Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests