Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Diesel Injector Service
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Diesel Injector Service
Can anyone recommend a good diesel injection specialist? I have a HJ60 with a/m turbo and I believe my 2H is due for some injector work. Smoke emissions is on the increase, yet depending on where I fill up with diesel will either make the car run good or ordinary...Does anyone else have this problem.
I am located in the North West sector of Sydney (if you don't know where Kenthurst is)!
Your advice is appreciated.
Cheers
Aaron
I am located in the North West sector of Sydney (if you don't know where Kenthurst is)!
Your advice is appreciated.
Cheers
Aaron
If you want a spare 60 for bits-
http://carl.outerlimits4x4.com/viewtopic.php?p=1109227#1109227
http://carl.outerlimits4x4.com/viewtopic.php?p=1109227#1109227
Do not ... I repeat DO NOT try to save a few bucks by buying 'cheap' diesel. The few cents a L that you save does not go very far when it comes time to rebuild your injector pump etc!!!
Only get your diesel from a reputable seller.
I thought mine was in need of some serious work but it turned out to be a single tank of poor fuel and the smoky emissions / rough running soon dissappeared after a couple of tanks of quality fuel.
Only get your diesel from a reputable seller.
I thought mine was in need of some serious work but it turned out to be a single tank of poor fuel and the smoky emissions / rough running soon dissappeared after a couple of tanks of quality fuel.
I've never been one to try and save a few bucks on fuel, to be honest the price never really worries me. If I need to fill up, i fill up. However, I have been paying particular attention to where I have been filling up. Monty and I have been looking for a servo where the diesel is not green, cause we thought this was giving us grief. Apparently the green is low sulfur diesel. Unfortunately, it is very hard to find a servo without this diesel anymore. We spoke to a fuel delivery guy from Caltex who said "stick with the big name companies and you wont go wrong, and you shouldn't get crap blended fuels." He said the green diesel is the common but there is also a gold diesel which is apparently even lower sulfur again.
The long and short of it is that someone suggested that I prolly need an injector service because the injectors are allowing the different grades of diesel to interfere with the spray pattern.
But I agree, there are definately different quality diesels, and they make a huge difference to perfermance and the way the car runs!
The long and short of it is that someone suggested that I prolly need an injector service because the injectors are allowing the different grades of diesel to interfere with the spray pattern.
But I agree, there are definately different quality diesels, and they make a huge difference to perfermance and the way the car runs!
If you want a spare 60 for bits-
http://carl.outerlimits4x4.com/viewtopic.php?p=1109227#1109227
http://carl.outerlimits4x4.com/viewtopic.php?p=1109227#1109227
Someone also told me that the low sulfur diesels aren't really good for older diesels as it tends to dry out and shrink the seals in the older injector pumps. Does anyone know if this is the case, and what can you do about it? e.g. Is there an additive available?
Also, can anyone recommend a good injector cleaner additive thats potent?
Also, can anyone recommend a good injector cleaner additive thats potent?
If you want a spare 60 for bits-
http://carl.outerlimits4x4.com/viewtopic.php?p=1109227#1109227
http://carl.outerlimits4x4.com/viewtopic.php?p=1109227#1109227
There is some interesting info in these threads:
http://www.outerlimits4x4.com/PHP_Modul ... php?t=9283
http://www.outerlimits4x4.com/PHP_Modul ... =additives
Also do a search on "additives". There are a lot of threads on here discussing them.
http://www.outerlimits4x4.com/PHP_Modul ... php?t=9283
http://www.outerlimits4x4.com/PHP_Modul ... =additives
Also do a search on "additives". There are a lot of threads on here discussing them.
carts wrote:Bogged,
I assume you have dealt with them before? If so, in general, what sort of cost am I looking at?
I know Mick Christie that worked for them, and West End built the Christie Creation and set it up, that thing smokes.
There was an article in one of the 4b mags on what they did to an 80, and it was very impressive. Cost when I called them was about $2000-2500 for pump rebuild, injectors, and dyno testing to what ever spec you like.
I have heard nothign bad about them, unlike someone to the south of there.. be careful what you say about them, they had lawyers onto another forum, for something that was said about them.!!!!
Who is online
Users browsing this forum: No registered users and 98 guests