Headin over to a mates place to do some wiring, apparently he is dumb and went to jumpstart his zuk but mixed the leads up and melted a heap of wiring (posative to negative with jumperleads) . No fuses were blown but car has no ignition lights.
Is there anything else he might have f-kd up that i should be looking for
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Fried Sierra - literally
Fried the immobiliser which was making trying to figure out what was wrong even harder. Because the immobiliser cuts the signal to the coil it copped the full wrath of the short, didnt blow any fuses but melted the wire to the ignition which the immobiliser went between.
Car now has no immobiliser which in my opinion is the way a 4wd should be, they cause nothing but dramas especially where water is concerned.
What a stooge even my missus knows which way jumperleads go on.
Car now has no immobiliser which in my opinion is the way a 4wd should be, they cause nothing but dramas especially where water is concerned.
What a stooge even my missus knows which way jumperleads go on.
Who is online
Users browsing this forum: No registered users and 31 guests