HJ60 air con layout with image

Post by **glenxr650** » Tue Feb 10, 2004 12:51 pm

I have fitted an original a/c kit supplied from a wrecker. When I install the belt it cannot be tensioned since it is too long. I measured an original belt and it is also too long. Am I missing an additional tension pulley?
The attached image is the arrangement I have:

Post by **glenxr650** » Tue Feb 10, 2004 2:42 pm

I'd better spend some time in the test section and practice on attaching an image!

Post by **bj on roids** » Tue Feb 10, 2004 3:51 pm

email me the image!

Post by **donk** » Tue Feb 10, 2004 3:52 pm

From memory on a 2H the belt goes crankshaft-compressor-ajustable idler-additional pully that was fitted to the water pump behind fluid coupling- back to crankshaft

I am only 99% sure this is correct as it is a long time since i fitted an a/c to one of these rockets

Email it to me as well if you want to sylviadon@hotmail.com & i will have a look

Regards Don

Post by **glenxr650** » Wed Feb 11, 2004 7:35 am

hope this works

Post by **bj on roids** » Wed Feb 11, 2004 8:03 am

That is how mine is :oops:

Post by **carts** » Wed Feb 11, 2004 9:22 am

Yep, thats exactly the 2h layout. If you want I can get the belt numbers off the belt for you this afternoon when i get home from work, just to make sure you have the right belt. I replaced them recently, and repco's numbers on the system were wrong. Perhaps someone gave you the wrong belt along the way.

Post by **glenxr650** » Wed Feb 11, 2004 9:39 am

If you could get me the belt numbers that would be great. I think someone has given me the wrong belt from the start.

Outer Limits 4x4 Board

HJ60 air con layout with image

HJ60 air con layout with image

Who is online