60 series electronic ignition conversion?

Post by **rattlinjack** » Sat Jul 11, 2009 9:45 pm

Looking to convert my 3f donk over to electronic ignition!!!!!!!!!!!!!!
So who knows all about this set up?????
Will be doing the same on my brothers 1987 Hilux.........

Post by **hiluxmad** » Sat Jul 11, 2009 10:00 pm

what system are you looking at?
pertronix are available for the cruiser
and i ran a crane cams on in my lux and ended up pulling it out and putting a standard electronic dissy in from a later 4y motor

Post by **rattlinjack** » Sat Jul 11, 2009 10:15 pm

hiluxmad wrote:what system are you looking at?
pertronix are available for the cruiser
and i ran a crane cams on in my lux and ended up pulling it out and putting a standard electronic dissy in from a later 4y motor

Gday mad, got no idea what system, I've seen a few advertised on flea bay etc. and thought I'd ask here before just grabbing one......

Post by **hiluxmad** » Sat Jul 11, 2009 11:20 pm

pertronix seem to be a good cheap system but there are people who have had dramas with them and the crane system is fairly exy i had dramas with it but i gave the car a real hiding.
just put the pertrinix in the missus car and the improvement was amazing no dramas so far

Post by **lokka** » Sun Jul 12, 2009 12:21 am

Ive used the crane fireball in my rangie for about 3 years now with no probs im also keen to see which system works best in the 3F ive seen the ones on ebay wich are a compleet dizzy swap for around 300 bucks ..
For the moment im happy to keep the points and carry a spare set as i cant see the point in spending 300 bucks on elec dizzy in a truck that only cost me $500 to buy

Post by **rattlinjack** » Mon Jul 13, 2009 9:27 am

thanks guys!!!!!!!!!

Post by **hulsty** » Mon Jul 13, 2009 12:25 pm

I've been using a modified VK commodore EFI dizzy in my 3F, works a treat with no problems. Starts to miss a little after hitting a deep mud hole at like 50km/h havent tried at all to seal it up etc yet

Post by **rattlinjack** » Mon Jul 13, 2009 2:03 pm

hulsty wrote:I've been using a modified VK commodore EFI dizzy in my 3F, works a treat with no problems. Starts to miss a little after hitting a deep mud hole at like 50km/h havent tried at all to seal it up etc yet

Now that's interesting!!!!
What mods did you have to do, to make it work???

Post by **Frankenyota** » Thu Jan 19, 2012 7:24 pm

Digging up an old thread.
Any info on this conversion?

Matt

Outer Limits 4x4 Board

60 series electronic ignition conversion?

60 series electronic ignition conversion?

Re: 60 series electronic ignition conversion?

Who is online