Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Tie down points aluminium tray.

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 655
Joined: Thu Mar 20, 2008 12:51 pm
Location: melbourne

Tie down points aluminium tray.

Post by Jacked »

I am installing some eye bolts into the back off my hilux for tieing down dirtbikes for trips away. basically the way im doin it is 1 eye bolt in each front corner and 1 in the front center of the tray that i will run 2 tie downs off (1 for each bike)

What im asking is will 55mm washers under the tray be enough to hold it down or should i be using a steel plate off larger size to stop it pulling through the tray.
Im more worryed about the center bolt as it will be holding both bikes and if it lets go will launch them off the ute.

Any other recomendations appreciated!
Top
Posts: 1072
Joined: Sat Aug 26, 2006 6:04 pm
Location: Melbourne

Post by Weiner »

Can you run a bit of flat with 3 holes in it the whole way across to tie them all in together?

I'd just make up a plate instead of the washer.
'89 Hilux Single Cab - 3RZ, 35" Kreepy Krawlers, 4.88's, F & R Air lockers, RUF, Longfields, TG Highsteer, Highmount and no money
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 5 guests