Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Clutch troubles

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 52
Joined: Wed Nov 20, 2002 1:39 pm
Location: Sydney

Clutch troubles

Post by Rexlux »

I have swapped a 1KZ-TE 3.0 turbo diesel and matching 5 speed into 84 hilux. Using stock 1KZ clutch and slave cylinder but 84 hilux master cylinder. The engine has only done about 12 000km (should not be worn out) and the take up point in the clutch pedal is right at the top. I am getting heaps of shudder when I take off.

Gearing is a bit high and getting a bit of axle wrap in the rear but it jumps like a bloody kangaroo down the road.

Could there be a miss match between the master and slave cylinder.

I think I will give it a good bleed and see if that helps.

Any thoughts would be welcome.
Top
Posts: 4275
Joined: Thu Dec 19, 2002 2:12 pm
Location: Sydney

Post by ozy1 »

maybe use a new master and match em up might help
Top
Posts: 428
Joined: Tue Oct 22, 2002 8:26 am
Location: The Sovereign Nation of Sealabia

Post by 2car »

Try shortening the pushrod that connects the pedal to the master, if you haven't already. Bad engine and gearbox mounts can cause shudder.
74 FJ40, 307, Hilux DBC, 35 Claws, welded rear.

'''_ ______
'/|_[_____]__
|?[_L/-\_|o=o|_
?:__;-?__-,==,_
()_)O()_)O== )_)
Top
Posts: 122
Joined: Wed Dec 10, 2003 9:19 pm
Location: Townsville

Post by paultherocksta96 »

The throw out bearing is stuffed or maybe the spigot bearing if it has one,these are the reasons for tall pedal and shudering.If the donk was sitting for a while the bearings could be bugged.
get the facts before the facts get you.
Top
Posts: 1513
Joined: Tue Oct 21, 2003 8:06 pm
Location: North East Melbourne

Post by ORSM45 »

tail shaft angles and steep gear ratios.
Top
Posts: 75
Joined: Sun Aug 29, 2004 5:24 am
Location: Anchorage AK

Re: Clutch troubles

Post by jr9162 »

Rexlux wrote:I have swapped a 1KZ-TE 3.0 turbo diesel and matching 5 speed into 84 hilux. Using stock 1KZ clutch and slave cylinder but 84 hilux master cylinder. The engine has only done about 12 000km (should not be worn out) and the take up point in the clutch pedal is right at the top. I am getting heaps of shudder when I take off.

Gearing is a bit high and getting a bit of axle wrap in the rear but it jumps like a bloody kangaroo down the road.

Could there be a miss match between the master and slave cylinder.

I think I will give it a good bleed and see if that helps.

Any thoughts would be welcome.


What was the solution?

JR
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 1 guest