ok first off i noticed me spotties would blink off then come back on, then they wouldnt work, flick the spotties switch a few times and they come on again. mate reackons its a relay. anyone else had this?
also my indicator would jus stay on with out blinkin a few times, only way to get it to turn off was to flick the indicator till it went out. anyone know wat i should be looking at?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
spotties and indacators dont work sometimes
Moderator: -Scott-
Try and pull the column apart and spray some contact cleaner on the connecting plates for the stalk. A lot of dust and grime gets in there.
Also I don't know what type of arrangement you have for your spot lights but you should check the signal wire connection for the spotlights. That’s going to be the one that should be connected to the high beam, working like an actuator.
However people connect them to parkers and low beam lights so that they can flash their spoties at any time. This is not legal. Not that anyone cares.
If all the connections are good, earth etc... Check the relay. Make sure that the in-line fuse ect... is secure.
Also I don't know what type of arrangement you have for your spot lights but you should check the signal wire connection for the spotlights. That’s going to be the one that should be connected to the high beam, working like an actuator.
However people connect them to parkers and low beam lights so that they can flash their spoties at any time. This is not legal. Not that anyone cares.
If all the connections are good, earth etc... Check the relay. Make sure that the in-line fuse ect... is secure.
i fixed the inacators.
the problem was when i hard wire my bull bar indacator two of the wires were touching each other, must of been the park ligths and indacotor. but i wrapped them in tape and now fixed that.
still havnt fixed me spotties. mite try and put a new relay in.
i took the stearing coloum out and had a look and sprayed with contact cleaner and hasnt done anything. so i reackon a new relay.
thanks for the help guys
the problem was when i hard wire my bull bar indacator two of the wires were touching each other, must of been the park ligths and indacotor. but i wrapped them in tape and now fixed that.
still havnt fixed me spotties. mite try and put a new relay in.
i took the stearing coloum out and had a look and sprayed with contact cleaner and hasnt done anything. so i reackon a new relay.
thanks for the help guys
Who is online
Users browsing this forum: No registered users and 5 guests