Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

GQ TD42 Engine Mount Vibe

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Forum rules
Post Reply
Posts: 766
Joined: Mon Dec 30, 2002 3:08 pm
Location: Melbourne

GQ TD42 Engine Mount Vibe

Post by jtraf »

Well I have just replaced the engine mounts in my auto GQ TD42 turbo with geniune nissan engine mounts.......

Prior to the change everything was fine other than making excessive noise when reversing up hill as th passenger mount was broken...

Since installing the new and I stress genuine Nissan $260 gold plated mounts I have a problem.....When accelerating hard or accelerating around a left hand turn it obviously contacts the retaining plate of the left engine mount....and when driving I can feel a slight vibe that wasn't there before.....

This did not happen prior to the change......Did Nissan change the design along the line or has the retaining plate design changed as I can not put up with this contact and vibration though the drive train???

Have others has the issue and what have you done to correct it?|

thanks
James
Top
Posts: 232
Joined: Sat Dec 05, 2009 6:33 am
Location: BUNDY

Post by RIZZO »

is it the 2 bolt pattern mount or 4, I have the 4 bolt mount and it seems fine, i got my non geniune mounts off ebay for 66 each
Top
Posts: 766
Joined: Mon Dec 30, 2002 3:08 pm
Location: Melbourne

Post by jtraf »

Mine are the four bolt type......I tried a set off ebay but the locating tabs did not line up with the mounts......that was another $130 experience....
Top
Posts: 232
Joined: Sat Dec 05, 2009 6:33 am
Location: BUNDY

Post by RIZZO »

jtraf wrote:Mine are the four bolt type......I tried a set off ebay but the locating tabs did not line up with the mounts......that was another $130 experience....
oh ok the auto must be a little different than the manuals, :(
Top
Yom
Posts: 1233
Joined: Tue Oct 16, 2007 1:13 pm
Location: Brisbane

Post by Yom »

there is no difference to the engine mounts whether it be an auto or a manual transmission. Only difference is 2 bolt vs 4 bolt for the GQs. There are a few different revisions of mounts although they all seemed to be interchangeable.

I had this issue too. Brand new genuine nissan enigne mount on the drivers side. Caused the fall out block thingo to contact the side of the retention cup. :roll: This only became apparent when i replaced the passenger side (I broke the drivers side before I tore the passenger side :lol: ).

Looked like it was caused by worn gearbox mounts on mine causing the motor to sit down too far at the rear. The drop boxes also did not help my cause as they made the transmission sit down ~5mm or so which angled the engine mounts.

Ended up living with it. Pretty sure I tore the mounts again not long after fitting them (3000rpm clutch dumps in low don't help)
Top
Post Reply

Return to “Nissan”

Who is online

Users browsing this forum: No registered users and 0 guests