Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Slip Yoke Dust Boot

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 113
Joined: Wed Mar 14, 2007 7:58 pm
Location: Canberra

Slip Yoke Dust Boot

Post by garrycol »

I have a one-off front drive shaft that is larger in diameter than standard. The builder put in an oil seal on the shaft to keep the grease in and the dirt out however it chews out after a few kms - even with the shaft greased up.

I am after a slip yoke dust boot to go on it but am having no luck - one end needs to have an inside dia of 2" (50mm) and the other end 2.5" (62mm) approx. Length needs to be about 4-6".

I have tried Hardy Spicer without any luck - any suggestions where I might get a boot.

Thanks

Garry
Garry
Top
Posts: 11
Joined: Fri May 27, 2005 3:36 pm

Post by EVIL73 »

I used to use a dirt bike front shock boot, just slip it over and either zip tie or you can use stainless steel c.v straps.

Ben
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 137 guests