Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Oil Leak At Swivel Hub ???

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 240
Joined: Sat Mar 20, 2004 6:38 pm
Location: far east gippsland

Oil Leak At Swivel Hub ???

Post by johno »

Not sure what the correct term is. But ive got diff oil coming out through the big seal on on the end of the axle housing. Is the problem the big seal or an internal axle seal.

Its only on the roght hand side, if anyone has has a sprare correct seal happy to buy it

thanks
Johno
Posts: 247
Joined: Wed Apr 19, 2006 9:13 pm
Location: Perth

Post by 84mksd33t »

it will be your inner axle seal OR:

you havnt had the diff out recently and the diff oil might have leaked out of teh breather and into the diff housing?
Posts: 240
Joined: Sat Mar 20, 2004 6:38 pm
Location: far east gippsland

Post by johno »

Mate the situation was that I had a bloke swap the complete front end over as my one had big problems, he assured me he replaced the inner axle seals. Ive had few doubts about that.

You have remove the swivel pins dont you to remove the axle and replace the seal.

Do you know if you can buy just the one inner axle seal

thanks
john
Posts: 897
Joined: Tue Aug 02, 2005 2:31 am
Location: Central Coast

Post by MyGQ »

you can get the inner axel oil seal from Repco, just did mine recently, $12 each.

to get to the seal you need to remove the manual free wheeling hub (or auto's if you have them) the wheel bearings, the brake's the rotor and hub then the stub axel, this gives you access to the CV joint, pull it out and then you will see he axel oil seal in the diff tube

also since you have oil leaking out, make sure you re-grease you CV and it may have washed the LMM grease out and if you don't re-pack it you will blow a CV, thats what i did :(
AA's for Quitters
Posts: 240
Joined: Sat Mar 20, 2004 6:38 pm
Location: far east gippsland

Post by johno »

Many thanks for the help & advise.

Would you happen to have the repco #, its manual hub & 1991 model

cheers
John
Posts: 6
Joined: Wed Mar 11, 2009 3:34 pm
Location: Campbelltown NSW

Post by Atrol »

If you go to the trouble of pulling everything off to get to the axle seal it would be a good idea to replace all the seals in the swivel housing at the same time. If you buy a swivel housing seal kit it will come with all the seals including the axle seals, swivel housing bearings and you can get the kit for as little as $135 as i just did. Better to have it apart once properly now then do half now and the rest in a few months.
Posts: 2775
Joined: Thu Apr 13, 2006 8:59 pm
Location: Melbourne

Post by GQ Bear »

Isn't it amazing how prices vary so much on parts, etc.

I always keep a spare inner axle seal with the spare cv i carry. Got a couple from repco for about $2 each.

Just bought a swivel hub kit the other day. Best price i could find was $190 :cry:

Hey johno it's not too hard to put a kit through (replace and repack all seals and bearings) and is good practice for if you bust a cv in the bush some day ;) Follow the step by step instructions in the Gregory's manual and you can't go wrong.
[color=violet]G[/color][color=white]O[/color][color=yellow] S[/color][color=blue]T[/color][color=yellow]O[/color][color=white]R[/color][color=violet]M[/color]
Premiers 1999, 2007, 2009
Spoon 2010
Posts: 240
Joined: Sat Mar 20, 2004 6:38 pm
Location: far east gippsland

Post by johno »

Fellas I just spoke to the bloke who did the job and he swears he put the full kit through it, looks like he might have damaged the seal when putting the axle back.

Johno
Posts: 305
Joined: Mon Apr 21, 2008 8:53 am
Location: New Zealand

Post by garth »

gudday Johno...

You are in NZ aren't ya? if you are call Don Kyatt Spare parts 092636021 they are the agents for 'Terrain Tamer' gear and they supply the likes of REPCO and BNT.

their website is terraintamer.com and they have all the gear for 4x4 rigs

regards garth
GQ with 30 PSI of TD42T.........
Posts: 240
Joined: Sat Mar 20, 2004 6:38 pm
Location: far east gippsland

Post by johno »

Thanks Garth

Cheers
Johno
Posts: 253
Joined: Thu Oct 19, 2006 8:03 pm
Location: Melb

Post by ORSM4B »

Dont buy Terrain Tamer seals they are crap....we bought 4 kits and all 4 kits put in the same weekend and they all still leak throu the seals....

Cheers Chris
Posts: 253
Joined: Thu Oct 19, 2006 8:03 pm
Location: Melb

Post by ORSM4B »

Dont buy Terrain Tamer seals they are crap....we bought 4 kits and all 4 kits put in the same weekend and they all still leak throu the seals....

Cheers Chris
Posts: 253
Joined: Thu Oct 19, 2006 8:03 pm
Location: Melb

Post by ORSM4B »

Dont buy Terrain Tamer seals they are crap....we bought 4 kits and all 4 kits put in the same weekend and they all still leak throu the seals....

Cheers Chris
Posts: 79
Joined: Wed Jun 29, 2005 2:12 pm
Location: Townsville.

outer axle seal

Post by Feenz »

I've replaced these seals twice and again on one side yesterday after blowing a cv. I'm guna say it, they all leak, CBC, BSC Motion Tech, REPCO, NISSAN, they have all leaked on me, making the grease a runny slop. My old MQ of 8 years back had inner axle seals but the GQ wagon runs oil in the axle it's self. I don't think this problem can be fixed.

Has any one seen an alternate seal with a feather edge instead of the multi ridge type????
Posts: 470
Joined: Wed Jan 24, 2007 12:21 pm
Location: Australia

Re: outer axle seal

Post by 351ciofgrunt »

Feenz wrote: but the GQ wagon runs oil in the axle it's self. I don't think this problem can be fixed.

What do you mean by this? Axles are solid steel
GQ Patrol Wagon, 6 point roll cage
351 cleveland, CHI heads, solid cam, Funnelweb single plane, 750 HP DP
Posts: 79
Joined: Wed Jun 29, 2005 2:12 pm
Location: Townsville.

Post by Feenz »

Axle housing, have a look in the manual, there are different diff/housings on LWB and Utes. My 89 GQ runs the axle through an Outer Oil Seal then through a slightly larger diameter bore then the rest of the axle housing upto the diff is full of oil.
Posts: 79
Joined: Wed Jun 29, 2005 2:12 pm
Location: Townsville.

Post by Feenz »

my mistake, bad choice of words.
Posts: 32
Joined: Tue Nov 17, 2009 7:03 pm
Location: Perth

Post by Chopz »

i had the same problem with this, the previous owner swears he replaced all the seals and it was good, but was still leaking, so i took it all apart to find he put swivel hub seal in backwards :roll:
Posts: 43
Joined: Wed Sep 24, 2008 2:36 pm
Location: perth

Post by rusty bus »

A slightly bent diff will also cause your inner axle seals to leak no matter what seals you use, Thats not to say they wont seal at first but after a decent 4wd with the front axles turning they tend to wear out very quickly. So just be wary if you tend to get drunk and jump your rig or are buying a 4WD off a young bloke with leaking axle seals.
Posts: 64
Joined: Sun Aug 26, 2007 4:49 pm
Location: perth W.A

Post by MUNGA GQ »

I have this problem two.
Fitted a new seal and speedy sleave, drove 2500hrs on the road, parked it up for 2 weeks no leaks. Take it out in the sand dunes for a run 150km park it up and the inner seal is leaking again.

If the diff is beat slighty how can you tell when the bent is and fit it?

Munga
RIGHT FOOT FOR GO!!!
Posts: 43
Joined: Sat May 14, 2005 4:51 pm
Location: Christchurch, NZ

Post by albundy »

I bought a heap of chinese ones about four years ago for $5 NZ each. They never leak, but then they get changed annually, along with the wheel bearings, inner and outer seals as well. If I bust a CV in the bush, they get changed as well.
Al
rain, hail, sleet or snow, we go!
Posts: 292
Joined: Sat Apr 29, 2006 2:32 pm
Location: New Zealand

Post by David_S »

I had a similar problem with the seals on the front diff on my MQ. On the MQ they are located at the diff head. Changing the seal made no difference. When I looked closely at the axle I found the seal had worn a slight groove in the axle surface. Fitted a speedi-sleeve about 3 years ago and have had no problems since. It was on the long axle side.

Before blaming seals have a good look at the axle first. It does not take much of a groove for the seal to leak
1982 Patrol K160 SWB (MQ) 4L P40 Petrol with Megasquirt fuel injection and EDIS ignition. Warn 8274 winch with Gigglepin head
Posts: 765
Joined: Fri Mar 12, 2010 7:28 pm
Location: Fixing something else the kids have broken

Re: Oil Leak At Swivel Hub ???

Post by BadMav »

johno wrote:Not sure what the correct term is. But ive got diff oil coming out through the big seal on on the end of the axle housing. Is the problem the big seal or an internal axle seal.

Its only on the roght hand side, if anyone has has a sprare correct seal happy to buy it

thanks
Johno
Be sure your steering limits are set correctly, mine kept leaking after a month after changing twice. Ended up finding that the steering limit was too far to the left and the cv would pinch the inner axle seal. adjusted the steering, put a new seal in and it hasn't leaked since.
Posts: 1578
Joined: Wed Aug 31, 2005 12:27 am
Location: In The Good Country

Post by sudso »

This has recently been discussed, search.
Most often the axle housing outer seat where the inner axle seal goes is damaged/scored by a seal puller, or the new seal is damaged on installation, usually by pushing down on the seal with the axle while reinstalling the axle into the diff centre.
The other most common is the swivel hub shims are the wrong thicknesses between top and bottom and so the axle isn't centered through the seal and rest of the hub.
Doesn't really matter what brand inner seals are used (although I think the genuine ones are the best quality and only about $13)
Bordertrek 4X4 & Fabrication
0400 250 734 Bordertown SA
I love terra firma-the less firma the more terra
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests