Taking the sump off in car?

[zc351]

Hi,

Can any one tell me how difficult it is to pop the sump off a 1hz in a 75 series with the engine in the car?

Have talked to 2 or 3 experts who say difficult too can't be done ...... but none have ever tried

Wondering if someone has done it and could tell me before i try as its my daily driver....... the next thing I'm doing is stop talking to experts.

Thanks

[RUFF]

Ive pulled the sump off 40 series cruisers before in car so i imagine it wont be any different in a 75.

[troopa]

i.ve done a thousand 78 series sumps in car working in the mines, not too hard job, have to drop draglink and tierod off. Its a dirty bastard of a job, if you have a go, be sure you drain the oil overnight before hand it'll save you alot of frustration trust me. A hoist makes it alot easier too if you have access to one.

[pricey]

Dropping the sump off a troopy is very simple, from memory nothing had to be removed for the sump to be removed. And definitely do as Troopa mentioned, and drain the oil the night before. It will obviously still drip a little oil out, and yes its a dirty bastard of a job

[Z()LTAN]

Removing the sump is easy as.... in theory.

Toyota glue them on with loctite grey from factory and can be a real bastard to take off.

When i took mine off i rekon i could have driven around for years without any bolts in it haha.

Just be pretty heavy handed with it, use a few screw drivers and pry them in around the lip, knock them in with a hammer like i had to.

Good luck

[Buggerific]

Be heavy handed?

You have to try to avoid bending the sealing surface as much as possible... When you get it off just lay it on a bench or something and try to lightly tap with a hammer and wide punch, or small socket to try to achieve a flat sealing surface again.

If it goes in warped and bent, chances are she'll leak again!

[Z()LTAN]

Nope,

I bent the shit out of mine when i took it off, had no choice.

Just bent it back and hammered it out a bit, put it back on with loctite grey and its sweet as

[80's_delirious]

I used a flat paint scraper to remove mine, hammered it in around the edges, with NO bending from bashing screwdrivers in bent the scraper, but it was $2 from Bunnings.

[Z()LTAN]

Maby it was just my 07 model engine..

I bent my screw drivers...

[zc351]

Righto then heavy handed it is,

So no other drama's? No interferrence from the pick up or anything silly like that?

Cheers

[Z()LTAN]

nah mate, just dont put the screw drivers too far in you may scratch or puncture something without knowing.

i.e pickup gauze, tube..

[spazbot]

just use a stanely knife push the blade through the sealant and run it round, that will cut the gasket and it will drop away.

[macca81]

just use a stanely knife push the blade through the sealant and run it round, that will cut the gasket and it will drop away.

x2

this will get a sump out quick smart 99% of the time.