I am currently doing some work on a BJ 47 Cab chassis land cruiser with the 2H engine.
Having a lot of difficulty getting the glow plugs to work.
From an old wiring diagram it looks like the person before me has complete removed the glow plug relay wire from glow plug warming lamp.
The wire from the glow plug relay to the glow plugs themselves is still there and looks to be intact.
The glow plugs them self are not receiving any current when you turn on the ignition to glow the plugs.
Most of the wiring under the dash looks to be ok with no indication of damaged or earth faults immediately apparent.
Any suggestions possible causes or tips on fault finding would be greatly appreciated.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
BJ 47 Glow Plug wiring problem
Moderators: toaddog, Elmo, DUDELUX
do you have to do something funky with the ignition to get it to glow?
on some i have seen they are glowed by turning the key past off, most are when you are in the on position though..
if you can see the wires and believe its intact then wire up a wilson switch to allow you to manually glow. if you do that and still no current to the glow plugs work backwards from there.
lots of info on ih8mud re: wilson switch.
on some i have seen they are glowed by turning the key past off, most are when you are in the on position though..
if you can see the wires and believe its intact then wire up a wilson switch to allow you to manually glow. if you do that and still no current to the glow plugs work backwards from there.
lots of info on ih8mud re: wilson switch.
Who is online
Users browsing this forum: No registered users and 0 guests