Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Slow windscreen wipers .... troopy

Tech Talk for Cruiser owners.

Moderators: toaddog, Elmo, DUDELUX

Forum rules
Post Reply
User avatar
V8Patrol
God of Magnificant Ideas!
Posts: 6774
Joined: Mon Aug 04, 2003 11:22 am
Location: Balls Deep

Slow windscreen wipers .... troopy

Post by V8Patrol »

Is this a common fault ?
both my troopy and the fatherinlaws troopy does the same thing........

when initally turned on the blades take forever to move accross the screen..... 6~7 seconds per swipe ( 12~14 secs for a full circut)
:shock:

changing the wiper speed has NO effect, they still wont wipe at a normal speed, just this slow almost struggling action.

After 10 minutes of opperation they begin to act like a normal wiper :?


Even switching them off for a few minutes and then turning them back on sees the same thing happening...... dead slow action that eventually comes good.


I'm guessing theres an issue with a bush for the arms or motor but want some tips before I start pulling it apart.


Kingy
[color=blue][size=150][b]And your cry-baby, whinyassed opinion would be.....? [/b][/size][/color]
Top
Posts: 286
Joined: Mon Jul 25, 2005 8:06 pm
Location: N.Q.

Post by bigbrowndog »

My HJ75 got so bad I bought a second hand wiper motor from Private Parts 4x4 in Sydney and swapped out the motors. It cured the problem but I have not pulled the wiper motor apart yet to see what was causing the problem. My wipers struggled like yours until they were obviously going to stop or burn something out trying to get going. regards
Top
Posts: 505
Joined: Wed Jan 25, 2006 9:19 am
Location: to the left of the post

Post by trains »

Most likely cause is a wiper motor that needs a few drops of oil on its bushes.

Have come across quite a number now that responded well to removing the motor.
Often no more than 3 bolts, earth wire, and pop out the knuckle joint from the wiper mech, remove cover, and a few drops of light sewing machine oil, castrol handy oil, you know what I mean etc, ,and a quick clean of the armature where the brushes wipe to remove excess dust etc.
There are 2 bushes, one at each end of the motor.
Another place where they can bind up is in the wiper posts, the supports that are under where the wiper arms are bolted to the shaft.
Dont be lazy and just oil these, they need to be removed and the shaft taken out, cleaned of the build up of dry grit and gunk, and regreased.
Far better results after those are looked at.

Also make sure you wiring is in good condition, no corrosion etc, but most likely its the motor, and the support bushes binding on the wiper shafts.

hope that makes sence.

Trains
Save the Whales......Collect the whole set.


My Wife Can't Shear..............But You Should See Her Crutch !
Top
Posts: 443
Joined: Tue Dec 25, 2007 6:03 pm
Location: Tasmania, Australia

Post by vk7ybi »

Seized wiper arm pivot bushings..
Top
User avatar
V8Patrol
God of Magnificant Ideas!
Posts: 6774
Joined: Mon Aug 04, 2003 11:22 am
Location: Balls Deep

Post by V8Patrol »

Thaks guys...... :armsup:


looks as if I'll be attacking it this w/end now I have a direction.

Kingy
[color=blue][size=150][b]And your cry-baby, whinyassed opinion would be.....? [/b][/size][/color]
Top
Posts: 505
Joined: Wed Jan 25, 2006 9:19 am
Location: to the left of the post

Post by trains »

So how is it working now mate??

what did you find?

T
Save the Whales......Collect the whole set.


My Wife Can't Shear..............But You Should See Her Crutch !
Top
Post Reply

Return to “Cruiser / Prado”

Who is online

Users browsing this forum: No registered users and 8 guests