V^ VP OVERHEATING

[v6delux]

hey guys got a v6 hilux conversion and its over heating (really ripping my nighty lol)
have changed thermostat and 2nd hand vp com radiator firred also water pump had thermo hard wired ( by desperation on the way to work) still no good any ideas any one running lux com conversion whats do i need to stop this over heating any help will be greatly apreciated

[berad]

Every man and his dog with a como motor in a hilux has the same problem, half would be busted arse motors, others need better radiators, different diff gears brings over revving and/or constantly loading the motor creating heat

rah rah rah

You put a big cheap motor in a small engine bay and these things happen

[v6delux]

Every man and his dog with a como motor in a hilux has the same problem, half would be busted arse motors, others need better radiators, different diff gears brings over revving and/or constantly loading the motor creating heat

rah rah rah

You put a big cheap motor in a small engine bay and these things happen

not quite the answer i was looking for i have replaced the thermostat water pump does not use water at all so guess counts out head agsket head ( tell me if im wrong) im consitering putting in new radiator and vt v6 twin thermo fans on swith hard wired will this help any info please
rexs at 2400 100 kms not over reving

[lay80n]

Have you acutally confirmed that either radiator you had fitted is clean and not clogged with a few hundred thousand km's of crap? What radiator do you have, have you bled any air from the system. A bit more infomation would be give people a chance to help you. Does it overhead straight away, or only when pushed hard up hill. What driveline are you running, tyres etc?
Hard wiring thermo fans is useless, it wont solve a problem. If the conversion is done properly then the fans will come on when the engine requires them to come on, and turn off when they are not needed. What general condition is the motor in. What condition is your radiator cap in, have you tried a new cap?

Have you checked what temperature it is reaching to rule out electrical glitches in the gauge. Temps up to 105 degrees are not abnormal, from memory fan on is just after 100 degrees. It is 105 on a VT, but not 100% sure on VP.

Layto....

[v6delux]

Have you acutally confirmed that either radiator you had fitted is clean and not clogged with a few hundred thousand km's of crap? What radiator do you have, have you bled any air from the system. A bit more infomation would be give people a chance to help you. Does it overhead straight away, or only when pushed hard up hill. What driveline are you running, tyres etc?
Hard wiring thermo fans is useless, it wont solve a problem. If the conversion is done properly then the fans will come on when the engine requires them to come on, and turn off when they are not needed. What general condition is the motor in. What condition is your radiator cap in, have you tried a new cap?

Have you checked what temperature it is reaching to rule out electrical glitches in the gauge. Temps up to 105 degrees are not abnormal, from memory fan on is just after 100 degrees. It is 105 on a VT, but not 100% sure on VP.

have bled it time and time again not 100% sure on the radiator ill slip the plastic tanks off and see! runs hot after 15 min driving hot or cold day ( i leave for work at 430am) single thermo is an after market job and IMO its shit i will put the hilux radiator back in and see how that goes it was only overheating on steep hills, have not owned the car long so condition of motor/ kms in unknown conversion was done 10 year ago thermo comes on when hot and when aircon is on

[chunks]

What temperature is it getting to?

[HUSSLN]

My lux had a high K motor and leaked from the heater pipe into the manifold, had almost no coolant in the whole system and the rad cap was shagged and with aircon on never over heated. It ran the standard deisel rad with one big thermo. But the overheating issue is very common an everyone runs a different system an its hit an miss.

[v6delux]

My lux had a high K motor and leaked from the heater pipe into the manifold, had almost no coolant in the whole system and the rad cap was shagged and with aircon on never over heated. It ran the standard deisel rad with one big thermo. But the overheating issue is very common an everyone runs a different system an its hit an miss.

temp hits 120 not boiling not sure if it cause its under presure or a false reading the temp guage sender is in the top hose had the thermomiter in and the hottest it got was 98 standing still temp was taken from the radiator tank and every chance it would be cooler in tank than outlet
running 30 inch tyers standard hilux diesel running gear including hilux g box anyone got pics of there systems whats evryones systems made of

[vk7ybi]

Pressurised water boils at a higher temperature than water at atmospheric pressure..

[surf__nut]

are u using the tans cooler in the radiator if so chec the trans fluid is not dirty if it is dirty change it dirty fluid is hot fluid .

[thehanko]

if it only overheated under hill load with the lux rad in it, then with the vp rad it was hot regardless, I would be looking into a more efficient radiator.

vp is pretty old so should at the very least be rodded.

my lux was getting a little hot going up hills, got a chinese radiator for it and it was terrible, got my origional re cored with an extra core and its never even thought about getting hot. excellent.

I would be looking into a more efficent radiator and go a recore so you know what your getting.

it was $490 for a recore 4 row hilux.

[TROY_86]

just rear mount a el falcon radiator with the twin thermo setup. wont come close to overheating again . my mate did this to his lux with a vp v6. standard water pump works fine.

he gave it a punishing in tuff truck last year and temp wasn't a issue

[v6delux]

any chance of posting a photo of falcon rad and thermos installed mountin options aswell please

[mike_nofx]

May be a stupid question, but did you bleed the air from the cooling system? Them v6's have a simple procedure to bleed air when replacing coolant

[Wooks]

I have a similar conversion (VN 6 to 90 4runner). The 22R Toyota radiator mine is fitted with supposedly has the capacity to cool the engine. Although my radiator is pretty old and had a couple of leaks recently (see "3.8 radiator issues please help" it's on page 2 atm), after I welded the holes up it ran just fine. There are a few suggestions on the other thread as well that might help you choose.

It sounds like as though your radiator is blocked up, I'm looking at replacing mine soon just to be sure and I've discovered that VN brand new replacements are going pretty cheap.

Also if your engine is mounted slightly high in the front I've found that because the drainage plug for the VN is towards the back of the motor, you need to raise the rear ax quite a bit to bleed the cooling system properly. You may have the same set up (although they moved the drain plug forward on later models).

The twin thermo falcon option sounds good too, photos pls??

[luxembuger]

I have an Ln106 which was a 2.8 diesel. Have retained the diesel radiator but am running a Marks engine fan, well originally was a Marks fan but have now modded the pulley to incorporate a viscous clutch for water crossings. An engine driven fan will pull approx 2/3rds more air than a thermo so no overheating problems for mine.

Cheers.

[old fella]

i have done several v6 conversion in hilux's and have never had a prolbem with over heating run diesel raditor with thermo fans, if running automatic box you need a exturnal raditor for auto oil, do not run oil lines through raditor, also have a bypass to switch thermos on when needed as the standard computer needs to be reprogramed to come on early,your gear change speeds are to tall for 4wdring in the autos, i put a manual shift kit into one and beefed whole box up, no more prolbems.

[Dane]

I ran a (brand new) four core HZ V8 radiator in mine and used the built in transmission cooler with good results. I had a 1 inch body lift.

[Wooks]

Just picked up a VS V8 radiator (as there is little size diff between 6 and 8, V8 is just thicker)

Will take pics when I install and let you know how it goes.

[Wooks]

Fitted a VR-VS V8 size radiator yesterday will let you know how it goes. Are you still having troubles?