Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
wheel studs
wheel studs
hey guys how easy and what do i need to replace rear wheel studs on gu ute? looked in bible and owners manual with not much luck. do i need to pull the whole axle out?? dont quite understand??? thanx
nah mate just hammer them out - from outside inwards. Then get new ones (shop around i suggest). Grease the crap out of them and poke them though form behind where the others came out, using a open ended wheel nut (usually they come with studs) on the outside tighten it up to pull new stud though.
Try to line the machines lines up on the inside of hole and studs to make it easier.
Try to line the machines lines up on the inside of hole and studs to make it easier.
Cant say i have done this on my Gu yet but have done it on other 4bs. As for taking the rotor off that depends on how much room you have behind there, its really just as easy too see if you can actually beat the stud out and put another one in from behind it with the amount of room, If not start taking stuff off till you do hehe. Hope this helpsjemmos wrote:ok, but do i need to pull the brake rotor off, or any thing?? thanx
Who is online
Users browsing this forum: No registered users and 124 guests