Hi
Anyone know if you can put a 100 series front end on a 80 series as in will the front guards and bonnet bolt up, I am pretty sure they would but was wonderring if anyone else has some ideas also the other one is if the doors from a 100 series fit onto a 80, front and rear i know the little buble thingo for the rear wheel arch will not fit up to the 80 but i have a dual cab 80 so i would modify the small bit behind the door to fit that. So generaly would front and rear doors front guards and bonnet from a 100 fit a 80 series???
Any help would be much appreciated
Oh the reason is I rolled my 80 did some damage down the side and can pick up a cheap 100 so working out if its cheaper to fix 80 or replace it with the 100 panels
Cheers
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Damaged 80 swapping with 100 panels, possible??
Moderators: toaddog, Elmo, DUDELUX
You can put an 80 series body on a 100 series chassis, so why not?
But seriously 80 bodies aren't so hard to find you'd have to consider using 100 series parts. I seriously doubt anything will just bolt up and fit.
But seriously 80 bodies aren't so hard to find you'd have to consider using 100 series parts. I seriously doubt anything will just bolt up and fit.
The worst part about being told you have Alzheimer's, is that it doesn't just happen once.
Who is online
Users browsing this forum: No registered users and 38 guests