on the front diff where the tail shaft joins... started leaking oil recently.
access by dropping the tailshaft?
any help is appreciated.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
there has to be a oil seal there right?
Also make sure you mark the nut to the pinion thread and the flange plate so you can do it all up to the same spot you undid it from. When you undo it count how many turns you undo it so it can be done up the same amount of turns and tightened to the same point it was before, if not a fanny hair tighter. Also use loctite on it to. I say the above because the nut wich holds the flange on also sets the preload on the pinion bearings, and if overtightened will overload them and also may change the cownwheel to pinion backlash if tightened to much.
cheers john.
cheers john.
is there a torque setting?~ if that works?rusty bus wrote:Also make sure you mark the nut to the pinion thread and the flange plate so you can do it all up to the same spot you undid it from. When you undo it count how many turns you undo it so it can be done up the same amount of turns and tightened to the same point it was before, if not a fanny hair tighter. Also use loctite on it to. I say the above because the nut wich holds the flange on also sets the preload on the pinion bearings, and if overtightened will overload them and also may change the cownwheel to pinion backlash if tightened to much.
cheers john.
Edit: 196 to 285 according to hienz manual.
Normally if tightening the pinion nut up for the first time with new bearings and a new crush washer used you would tighten the nut up bit by bit while continually checking the amount of force needed to turn the pinion (without crownwheel and carrier in). Once it reaches a certain amount of torque needed to turn the pinion this is where they leave it. There is a set torque setting for the drag required to get correct preload on the bearings but you would use a spring scale to measure this which you dont need to do seeing as it has already been set.
As long as it goes together the same way you took it apart and the nut ends up in the same spot it will be good. As i said even a fanny hair tighter wont hurt just to give you peace of mind it wont come loose but be sure to use loctite just in case. It takes a certain amount of torque to crush the crush washer more making the preload greater but its quite easy to do the old "one more and ill leave it" trick and end up overdoing it.
As long as it goes together the same way you took it apart and the nut ends up in the same spot it will be good. As i said even a fanny hair tighter wont hurt just to give you peace of mind it wont come loose but be sure to use loctite just in case. It takes a certain amount of torque to crush the crush washer more making the preload greater but its quite easy to do the old "one more and ill leave it" trick and end up overdoing it.
Last edited by rusty bus on Sun Apr 18, 2010 10:35 pm, edited 1 time in total.
Who is online
Users browsing this forum: No registered users and 156 guests