Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

TD42 GQ UTE RUMBLE IN DRIVE LINE WHEN COASTING

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Post Reply
Posts: 103
Joined: Sat Dec 19, 2009 9:27 pm
Location: Ipswich

TD42 GQ UTE RUMBLE IN DRIVE LINE WHEN COASTING

Post by tufftruckin »

As stated in the title my patrol has a rumble in the driveline, I have eliminated the tail shaft from the equation and it still does it is it the transfer case, gear box or rear diff? has anyone else had something simillar? it also has a brief runble when taking off arond a corner in 1st & 2nd!
An ounce of precaution is better than a ton of cure!
Posts: 765
Joined: Fri Mar 12, 2010 7:28 pm
Location: Fixing something else the kids have broken

Post by BadMav »

Check all your rear bushes and the engine/gearbox mounts.
Don't take life too seriously...it isn't permanent.
Posts: 43
Joined: Wed Sep 24, 2008 2:36 pm
Location: perth

Post by rusty bus »

mate i have the exact same thing when im coasting, anywhere above around 40km/h it will do it, especially at high speed like the freeway. you have the drive train so there is no load on the diff and perfectly coasting and it kinda sounds like when you run over those white lines on country roads that are textured and raised to make noise. I have replaced my rear diff and its still there, im assuming its the transfer case but anyone else who has had this problem and found what it was would be good to hear from you!!
Posts: 45
Joined: Mon Mar 30, 2009 1:34 am
Location: Gove, NT

Post by Braddels »

Loose rear sway bar can make a rattle when low speed cornering, After climbing under and shaking everything by hand this seems to be the most obvious. Worn exhaust mounting rubbers could also be a cause. Let us know if you pinpoint and fix the problem.
Posts: 75
Joined: Mon Aug 24, 2009 11:33 am
Location: GLADSTONE QLD

Post by MEGATROL »

i know you said you eliminated the tailshaft, so wat did you change or check to eliminate it???

my brother had a shorty GQ and it did the same thing and it happend to be slop in in the slip joint on the rear tailshaft.

Pickels
Posts: 103
Joined: Sat Dec 19, 2009 9:27 pm
Location: Ipswich

Post by tufftruckin »

rusty bus wrote:mate i have the exact same thing when im coasting, anywhere above around 40km/h it will do it, especially at high speed like the freeway. you have the drive train so there is no load on the diff and perfectly coasting and it kinda sounds like when you run over those white lines on country roads that are textured and raised to make noise. I have replaced my rear diff and its still there, im assuming its the transfer case but anyone else who has had this problem and found what it was would be good to hear from you!!
Thats exactly what it sonds like, you described how it does it and how it sounds perfectly. I eliminated the tail shaft by exchanging it with a mates then removed it totally and drove in 4wd and it was still there. how hard is it to change your transfer over or how much roughly to rebuild it?
An ounce of precaution is better than a ton of cure!
Posts: 45681
Joined: Wed Nov 27, 2002 10:13 am

Post by bogged »

every patrol I've been in has had a rumble in the driveline. :?:
Posts: 345
Joined: Wed Dec 24, 2008 11:58 am
Location: Mackay

Post by tye1986 »

i have a similiar noise but it wlaso wines between 60 - 70 changed the grade of oil in my transfer stopped the grumble and made the wine alot quieter after pulling the rear diff out twice and swapping tailshafts and unis that is hahah
gq coil cab with stuff
Posts: 109
Joined: Fri Jul 01, 2005 6:44 pm
Location: broken hill

Post by gouldy »

Transfer case chain may be a little loose. No problem realy.
It is standard for some Td42s to make a little noise but I havn't heard the same noise in a petrol model. Try some thicker oil , often works well.
GQ. Supercharged LSX 427, 500rwkw. camtech cam,90mm Holley Throttle Body. twin 4"exhaust, big fuel system, King bypass shocks and bumpstops.
Posts: 43
Joined: Wed Sep 24, 2008 2:36 pm
Location: perth

Post by rusty bus »

Yer i might throw her on a hoist and change the oil, see how she goes.
Posts: 75
Joined: Mon Aug 24, 2009 11:33 am
Location: GLADSTONE QLD

Post by MEGATROL »

this mabey a stupid question, but are ur freewheeling hubs locked in???? cos this will vibrate the driveline in my ute because of the angles on the front tailshaft, so if you have removed the rear tailshaft and driven in frontwheel drive your hubs would have been in, so make sure there in "FREE" when ur daily driving,

also How much lift is in your rig??

Pickels
Posts: 103
Joined: Sat Dec 19, 2009 9:27 pm
Location: Ipswich

Post by tufftruckin »

MEGATROL wrote:this mabey a stupid question, but are ur freewheeling hubs locked in???? cos this will vibrate the driveline in my ute because of the angles on the front tailshaft, so if you have removed the rear tailshaft and driven in frontwheel drive your hubs would have been in, so make sure there in "FREE" when ur daily driving,

also How much lift is in your rig??

Pickels
freewheeling hubs are definately on free, removed the front tail shaft today and drove in 2wd as i always do and it is still there, definately right under me, truck has 2" suspension lift and 2" superior extended shackles. did it b4 i put the shackles in! have changed tyres ect, I'm interested in the loose chain in transfer, can it be tensioned?
An ounce of precaution is better than a ton of cure!
Posts: 103
Joined: Sat Dec 19, 2009 9:27 pm
Location: Ipswich

Post by tufftruckin »

ok soo i pulled the centre out to put air locker in! whilst examining the rest of the diff i noticed there was alot of play in the wheel bearings! i'm assuming they are stuffed! having them replaced! hopefully this sorts out my noise problem
An ounce of precaution is better than a ton of cure!
Posts: 4
Joined: Fri Jul 13, 2007 7:25 pm
Location: Lithgow

Post by xrmeier »

my 04 ute also has a rumbling noise i think its the gearbox/transfer its really noticable when in low range and applying the throttle after idling along and when labouring it
Posts: 897
Joined: Tue Aug 02, 2005 2:31 am
Location: Central Coast

Post by MyGQ »

i have the same noise and its my Rear Pinion bearing heading for a bit of a bang i recon soon
AA's for Quitters
Post Reply

Who is online

Users browsing this forum: No registered users and 15 guests