Hey there folks,
I was wondering how to exchange the drive flange seal in the front diff of a y60 since it is leaky.
Can I just loosen the locknut and pull off the flange or wil my pinion drop out?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
drive flange seal
n
Its easy
Take the load off the diff (unlock the hubs or jack it up) gears.
remove tailshaft
big pipe on socket as its fairly tight - I made a flat bar with some bolts to lock the drive flange and rested the end on the ground to hold it steady
rip out seal
fit new seal
I did both mine recently - no dramas.
Oh, go the genuine seal as the aftermarket ones were not the same. I paid $29 each from Nizzbits
Take the load off the diff (unlock the hubs or jack it up) gears.
remove tailshaft
big pipe on socket as its fairly tight - I made a flat bar with some bolts to lock the drive flange and rested the end on the ground to hold it steady
rip out seal
fit new seal
I did both mine recently - no dramas.
Oh, go the genuine seal as the aftermarket ones were not the same. I paid $29 each from Nizzbits
Who is online
Users browsing this forum: No registered users and 2 guests