Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Interior light problems in GQ

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Forum rules
Post Reply
Posts: 54
Joined: Mon Mar 01, 2010 2:00 pm
Location: Elimbah Qld

Interior light problems in GQ

Post by v8maverick »

Hi guys ive got a weird problem with the interior light in me gq wagon
it keeps blowing the fuse if i have both front and rear light bulbs in.
But if i only put one bulb in it don't do it. dosent matter weather its the front or rear.
Any ideas?
matt
Ford maverick with 5.0L EFI windsor
Top
Posts: 3
Joined: Sun Mar 08, 2009 10:29 am
Location: Perth WA

Post by choochie »

Ha I got the same problem :/ But its mainly the front one that blows each time. If I can't find the problem then might fit with LEDs which don't blow ... but that is just masking the issue!
Top
Posts: 29
Joined: Fri Apr 24, 2009 6:34 pm
Location: Melbourne

Post by GeeC »

What is the rating of the fuse and globes?
Top
Posts: 54
Joined: Mon Mar 01, 2010 2:00 pm
Location: Elimbah Qld

Post by v8maverick »

don't matter what fuse is it it still blows.
2x 5 watt globes
Ford maverick with 5.0L EFI windsor
Top
Posts: 29
Joined: Fri Apr 24, 2009 6:34 pm
Location: Melbourne

Post by GeeC »

The fuse for the interior lamps should be 10A.

There is power available at each light at all times, and the fact that you have to have both globes installed to blow the fuse seems to indicate an overload condition.

The fuse also supplies power for the clock and radio - maybe disconect those to see if the problem still occurs.
Top
Posts: 121
Joined: Wed Dec 24, 2008 6:39 am
Location: pomona, sunny coast

Post by grinch2 »

it sounds like overload, but the fact that the bulbs draw a lot less then 1 amp, i doubt that it would be the case. check that the wires haven't been pinched under the light fitting. a trick to finding a short is to remove the fuse and but a headlight bulb in its place (solder a couple of wires to the bulb and some male spade terminals to go into the fuse holder) the bulb will glow dull or not at all depending on the current draw, if there is a short it will glow bright, then you can go threw shaking the harness etc, until the light goes out, your short will be in that area.

shorts can be a pain to find, you may end up pulling half the car apart. :bad-words:
Top
Posts: 29
Joined: Fri Apr 24, 2009 6:34 pm
Location: Melbourne

Post by GeeC »

If the supply wire is pinched or shorted anywhere, then the fuse would blow regardless of whether a globe was installed, plus there is the fact that both globes must be installed for the fuse to blow.

If the switch wire was pinched or shorted, the light would just be on, regardless of the door switches.

Are you sure they're not 50W globes instead of 5W - unlikely I know, but it would explain it.
Top
Posts: 2388
Joined: Sun Nov 24, 2002 10:20 pm
Location: bacabugari

Contact:
Contact big red

Post by big red »

globes too long ?
maybe your shorting a terminal post when putting them in ?
[url=http://bigred.redbubble.com/][color=red][b]You can follow me but its gunna hurt ![/b][/color][/url]
event pics http://bigred.redbubble.com/
Top
Posts: 218
Joined: Thu Jun 26, 2008 6:41 pm
Location: Bundy, QLD

Post by rumpig89 »

big red wrote:globes too long ?
maybe your shorting a terminal post when putting them in ?
he said he can have either one in by itself no probs..
Top
Post Reply

Return to “Nissan”

Who is online

Users browsing this forum: No registered users and 1 guest