hey guys, not sure if this is the best place to put this question to the masse, but i figured small blocks ore going into more than just cruiser's and patrol's. Moderators please feel free to tell me where to stick my post
How much (at a minimum) oil should i put into my chev V8 (first fill after build)? Only asking as i've found after some net searches a general requirement of 4qt (4.4~ L) plus filter, but these were on hotrod sites...i was concerned about any possible differences in the sump mainly on a 4x4 engine?
Guys with chev's in their 40's 45's 60's 80's MQ's GQ's etc i'm asking basically how much you put in.
Don't want to sound like a tard for asking, but i also don't want to hear a knocking at the proverbial door.
I'm also using an aftermarket bling dipstick, which i figure i will mark according to my filling needs
cheers Tim
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
oil capacity in small block chev (307)
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Re: oil capacity in small block chev (307)
cheers guys,
I've got 4.5 L in to be 'safe' so that should at least be plenty to crank it over without the plugs in, I'll probably add a little more once its running.
351ciofgrunt, I wasn't sure if I had a dipstick that was too long/short for my sump, which has been that case with a mate of mine; The dipstick in his cleveland had been showing full, so he assumed it was full (he bought the vehicle with the engine in it). Every now and then he'd hear a little knock pulling up to traffic lights after a long cruise up the highway...figured the oil pump was on its way out...drained the oil to pull the sump off and replae the oil pump...only 1L comes out.
Having had this happen to someone i know, i thought it'd be reasonable to ask for a round-about volume and work on the law of averages.
Much appreciated, Thanks
I've got 4.5 L in to be 'safe' so that should at least be plenty to crank it over without the plugs in, I'll probably add a little more once its running.
351ciofgrunt, I wasn't sure if I had a dipstick that was too long/short for my sump, which has been that case with a mate of mine; The dipstick in his cleveland had been showing full, so he assumed it was full (he bought the vehicle with the engine in it). Every now and then he'd hear a little knock pulling up to traffic lights after a long cruise up the highway...figured the oil pump was on its way out...drained the oil to pull the sump off and replae the oil pump...only 1L comes out.
Having had this happen to someone i know, i thought it'd be reasonable to ask for a round-about volume and work on the law of averages.
Much appreciated, Thanks
78 fj40 soft top, lift, 33's on 15x10's, bars front and back
74 fj45 tray, very soon to be 307, 35's, lockers and full og touring goodness
74 fj45 tray, very soon to be 307, 35's, lockers and full og touring goodness
Who is online
Users browsing this forum: No registered users and 0 guests