went and order my beadlocks today,
i could have got any thickness i wanted up to 15mm for the inner and outer rings and any number of bolts i wanted up to 36.
the locks have a height of 50mm and take 10mm flush mounted allen head bolts.
so i went with........
ROH 22mm offset wheels
12mm inner with a 6mm bead seat.
10mm alloy outer (for weight) with a 2mm seat so the rim has a mounting face of 8mm.
20 bolts
good bad thickness? number of bolts, your thoughts?
NICK
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
beadlocks
Moderators: toaddog, TWISTY, V8Patrol, Moderators
beadlocks
TECH SCREW GURU
Nick what did you end up paying for them. 
8 mm seat, does that mean the bead is going to squash down to 8 mm too.
Why only 20 bolts, why not 36 (less torque is required for same amount contact pressure) was there a huge differance in price
Do you have a picture
And finally where did you get them from
8 mm seat, does that mean the bead is going to squash down to 8 mm too.
Why only 20 bolts, why not 36 (less torque is required for same amount contact pressure) was there a huge differance in price
Do you have a picture
And finally where did you get them from
POS wrote:Nick what did you end up paying for them.
8 mm seat, does that mean the bead is going to squash down to 8 mm too.
Why only 20 bolts, why not 36 (less torque is required for same amount contact pressure) was there a huge differance in price
Do you have a picture
And finally where did you get them from
too many questions there adrain.
i didnt get 36 cause it would have cost about 15 bucks more and apparntly it is harder to get them to seal, i talked to afew people about them and i was advised between 16-24 was the best amount, so i went with 20, down the middle, i originally went with 24 but with some thought changed it to 20.
with the 8mm seat, yes that means that the bead is going to squash down to 8mm, most are only 5 and dont ream the outer ring that 2mm either.
No picture, if i had taken my digital i could have got some, but they are a strong tuff looking beadlock.
the price mmmmmmm yeah about that
NICK
TECH SCREW GURU
Who is online
Users browsing this forum: No registered users and 5 guests