Just moving some stuff around the shed and I have a Gen3 LS1 that was going into the Hilux, but I have a T350 with NP203 transfer that could finish off the project. The issue I have is that the bolt patterns between the gen2 and gen3 Chevy are slightly different (only one bolt doesn't line up), but is that all that is different? If I ignore that top bolt, or do some welding to add another tab to the T350 is the shaft/crank alignment the same, and spacing between the two?
- David.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Gen3 vs Gen2 Chev Bolt Pattern
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Gen3 vs Gen2 Chev Bolt Pattern
Need a bigger shed...
Re: Gen3 vs Gen2 Chev Bolt Pattern
Most just bolt it up.
Watch the crank length as they are different though and you will need a spacer
Watch the crank length as they are different though and you will need a spacer
ADHD Racing would like to thank
Mrs Bru @ Sunshine Coast Developmental Physiotherapy - www.scdphysio.com.au , Ryano @ Fourbys www.generaltire.com.au Blitzkrieg Motorsport
Mrs Bru @ Sunshine Coast Developmental Physiotherapy - www.scdphysio.com.au , Ryano @ Fourbys www.generaltire.com.au Blitzkrieg Motorsport
Re: Gen3 vs Gen2 Chev Bolt Pattern
I dont think the turbo 350 will last.
Chris
Chris
Who is online
Users browsing this forum: No registered users and 1 guest