Ive nearly finished fitting a 1GGTE to my 86 4runner and was Just wondering if anyone has had much experience with the 1st gen 1GGTE engines?
My problem is that i cannot get error codes from the motor by bridging t1 and E in the diegnostics plug.
When the engine gets to full boost it cuts out completely and the battery has to be disconnected for at least 5 or 10 minutes before it will start again. When the motor is cold it takes at least 10 to 15 seconds of cranking before it will fire and even then it runs rough for about 20 seconds. Sometimes after it has been run and then stopped it will not start at all as there is no spark... Anyone got any ideas as to what it could be or where in melbourne i could get this sorted?
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
1GGTE 4RUNNER help
Moderators: toaddog, Elmo, DUDELUX
Re: 1GGTE 4RUNNER help
Still using the factory ECU ?? If so, you will be using the factory air flow meter (between the air box and the air inlet "T" piece that feeds into the turbo's). These are a PITA, and cause these types of symptoms when stuffed. If its a Gen 1 1ggte, thens its at least 24-25 years old. Is yours water to air i/cooled?
Phill
1995 DX 80 series, brought to you by:- 1HDFTE, A750, PWR, Secret Squirrell Steinbauer, BFG, GME, Engel, ARB, Kaymar, and my empty wallet!
1995 DX 80 series, brought to you by:- 1HDFTE, A750, PWR, Secret Squirrell Steinbauer, BFG, GME, Engel, ARB, Kaymar, and my empty wallet!
Re: 1GGTE 4RUNNER help
who wired it up?
what fault codes are you getting when you short te1 and gnd
if none then the computer is wired wrong or is stuffed
what fault codes are you getting when you short te1 and gnd
if none then the computer is wired wrong or is stuffed
80 series 1980 hilux cab supra twin turbo engine
1hdfte 80 series
LHD fz 80 series GX
1hdfte 80 series
LHD fz 80 series GX
Re: 1GGTE 4RUNNER help
yeah its still the factory ecu and its running a fmic. iv tried shorting t1 and e and no fault codes come up so ill try t1 to ground and see if i can get any codes out. it was wired when i bought it but im not sure who did the work. Ive worked out that if you block the fuel return while cranking the motor over it starts alot easier soo i might put a solenoid on the return to fuel pressure up while it starts.
Re: 1GGTE 4RUNNER help
fuel regs stuffed
Boondall backyard performance...SHANTYTECH 4034...
BMX bike - 20" maxxis stickies, 4130 tube frame, reduction gears.
BMX bike - 20" maxxis stickies, 4130 tube frame, reduction gears.
Re: 1GGTE 4RUNNER help
^^^^^^^ What he said !!
Phill
1995 DX 80 series, brought to you by:- 1HDFTE, A750, PWR, Secret Squirrell Steinbauer, BFG, GME, Engel, ARB, Kaymar, and my empty wallet!
1995 DX 80 series, brought to you by:- 1HDFTE, A750, PWR, Secret Squirrell Steinbauer, BFG, GME, Engel, ARB, Kaymar, and my empty wallet!
Re: 1GGTE 4RUNNER help
The 'E' pin is ground, if it isn't your ECU won't be seeing a proper earth connection.ryzzy wrote: iv tried shorting t1 and e and no fault codes come up so ill try t1 to ground and see if i can get any codes out.
Does the car run OK with a line lock on the fuel return? or does it still cutout under boost and fail to start after that?
Who is online
Users browsing this forum: No registered users and 22 guests