Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

electrical question G16B MPFI

Tech Talk for Suzuki owners.

Moderators: lay80n, sierrajim

Forum rules
Post Reply
Posts: 32
Joined: Sun Feb 10, 2008 4:46 pm
Location: townsville

electrical question G16B MPFI

Post by tazmanier »

Ok I am putting in the G16B MPFI from a 96 Vit into my 89 sierra. 3rd year I’ve been doing this now and just got enthusiasm to try and make the engine work again. I did a lot of things backwards (was a bit naive back then) including not check that the MAF sensor, O2 sensor or resistor condenser came with the engine when I bought it. So with replacement MAF and O2 sensors bought and installed (and a lot of $ spent)I just need a resistor condenser OR know what values the capacitor and resistors are to make my own. Here are the wiring diagrams I have been using but if anyone else has better ones please let me know.
Does anyone know what these values might be?
OR even better know where the resistor condenser can be found on a Vitara so I can go hunting though the car bone yards?
OR even way better have a spare one about?

Image

Image


Thanking you all.

-Sean
Top
Posts: 904
Joined: Mon Feb 19, 2007 6:10 pm
Location: Perth

Re: electrical question G16B MPFI

Post by mrRocky »

seems like you might be overcomplicating things mate, they run with only 4 wires connected from the loom
_____

[olllllo]
Top
Posts: 3098
Joined: Sat May 28, 2005 3:22 pm
Location: Melbourne, Australia

Re: electrical question G16B MPFI

Post by PJ.zook »

I made up a custom wiring diagram for G16B conversions into sierra but its for MAP sensors not MAF, not sure if it would help you or not.
Motorized three seater couch buildup:

http://www.outerlimits4x4.com/viewtopic ... 0&t=196047
Top
Posts: 32
Joined: Sun Feb 10, 2008 4:46 pm
Location: townsville

Re: electrical question G16B MPFI

Post by tazmanier »

seems like you might be overcomplicating things mate, they run with only 4 wires connected from the loom
This is probably the case but simplifying it and just connecting brown with white trace (NW) and brown wires (N) [after all a condenser is just to take out the radio noise isn’t it?] doesn’t work. I still get the fault code 41 (ignition fail safe signal) and no spark while cranking. Do you actually need the brown wire input (A8 pin on the connector) for the ECU to work??

Also had another look at the second picture I've posted and it’s for a single point injection so probably not useful for me but the first is right .

Cheers for the info so far.

-Sean
Top
Posts: 12
Joined: Sun Oct 02, 2005 1:58 am
Location: Sydney

Re: electrical question G16B MPFI

Post by TNT4x4 »

i cant help either sorry i put the tbi into mine and the resistor has only two wires through a yellow plug, but i know on my front clip the resistor was on the l/h inner guard that may help you
Top
Post Reply

Return to “Suzuki”

Who is online

Users browsing this forum: No registered users and 1 guest