Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

TD42 cupped injector washer - which way up?

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Forum rules
Post Reply
Posts: 569
Joined: Sun Jan 11, 2004 11:36 am
Location: Sunshine Coast QLD

TD42 cupped injector washer - which way up?

Post by Mark2 »

With the new set of injectors came a small silver cupped washer which goes at the very tip of the nozzle in the head. Does the flat side of the washer go towards the washer or the head?
Thanks
Top
Posts: 494
Joined: Tue Mar 15, 2011 11:24 am

Re: TD42 cupped injector washer - which way up?

Post by Northside 4x4 »

I normally put the flat side to the head, but either way it will make little difference.
They get squashed to about 70% of their original once the injectors are done up.

Most of the ones I pull out are some up some down...
Top
Posts: 748
Joined: Tue Nov 09, 2004 9:45 pm
Location: Lilydale

Contact:
Contact Dzltec

Re: TD42 cupped injector washer - which way up?

Post by Dzltec »

The flame and compression washers are copper and it doesn't matter which way they go. It sounds like you have toyota steel heat shields. I personally would be asking for the correct units.

Andy
www.diesel-tec.com.au Ph 03 9739 5031
Ball bearing turbo upgrades for factory turbo vehicles. Got a diesel question just ask.
Home of the twin turbo shorty and many 150rwkw+ patrols.
Top
Posts: 494
Joined: Tue Mar 15, 2011 11:24 am

Re: TD42 cupped injector washer - which way up?

Post by Northside 4x4 »

I think he does have the right ones Andy, I think its mostly the aftermarket seals that use the convex top and flat bottom though.
Top
Posts: 155
Joined: Wed Dec 20, 2006 12:11 pm
Location: Rockhampton

Re: TD42 cupped injector washer - which way up?

Post by sswaffie »

Dzltec wrote:The flame and compression washers are copper and it doesn't matter which way they go. It sounds like you have toyota steel heat shields. I personally would be asking for the correct units.

Andy
Like andy said get the proper ones as this helps take the heat from the nozzle
Top
Post Reply

Return to “Nissan”

Who is online

Users browsing this forum: No registered users and 0 guests