Garrett turbo on 1hz

[Glux]

Im putting a big Garrett on my 1hz but it looks like that waste Gate is going to hit the engine block, has anyone come across this before? And what have they done?

[4x4fabrications]

hay there i fitted a huge gt30/76 roller turbo the 3 inch inlet just cleared the engine mount and had to mod the wase gate actuator which was no big problem im sure yours will fit

[Glux]

Ok, mine is a gt32/76, that's what I'm needing to know on how to do the waste gate side of things, do you have any pics of yours?

[ledgend80]

this is what i had to do to fit my gt2871 to my 1hdt

before



where the wastegate hit the block




after

[Z()LTAN]

It depends entirely on what manifold/adapters you use.

I used a DTS manifold and a 2 piece adapter, this brought the turbo just far enough away from the block and engine mount to need minimal waste gate actuator modifications.

Here is an old pic of mine, a GT2876r. Even the 4" inlet clears the engine mount easy.

[Glux]

I'm using a denco manifold that the turbo bolts straight up to

[Roffy88]

hey, what did you guys do to your engine to stop the over heating in the pistons and the head? i just droped compression in my third piston, to pull the engine down and find 5 out of 6 pistons cracked, one fully in half, and the bottom of the head with cracks all through it. its a 1hz with a safari turbo kit. im planning on rebuilding the motor and trying again with the turbo, got any ideas what to do to help from this happening again?

[Z()LTAN]

Keep your egts in check below 550 post
intercool
fit an aneroid (boost compensator)

I havnt looked at the inside of my engine in some time but it still goes bloody great.

I spose im just one of the lucky few.

[cruzinnboozn]

Zoltan, How many K's had your 1HZ done when you bolted the turbo on

[Z()LTAN]

about 3000 lol

[fumduk3]

how is your 2876 going on your 1hz zoltan? still sweet?

[Z()LTAN]

Yeah mate its a bit worn out now but still going great. Cant fault it.