Hi there,
I've got a EBI-100HD isolator that was already installed in my 100 series cruiser new about 10 years
It's been working perfectly until this week
The alternator is putting out around 14.5v and the main is charging fine and there is around 14.5v going into the main batt post of the isolator.
I pulled it apart, it was very clean with no corrosion inside, manually connected the contacts and 14.5v was at the aux post
Problem is the isolator is not automatically connecting
Any advise on replacing certain resistors or LM chips would be great.
I work in the electronics field so this kind of component replacement would be no trouble.
Cheers
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Batt isolator not connecting
Moderator: -Scott-
Re: Batt isolator not connecting
Hi Rough, have you got the IC part numbers and also check to see if the circuit has a voltage regulator or zener diode for controlling the voltage.
2007 TDV8 Range Rover Lux
2009 2.7 Discovery 4
2009 2.7 Discovery 4
Who is online
Users browsing this forum: No registered users and 15 guests