Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Ignition timing on 308
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Ignition timing on 308
Just wondering if anyone can help me regarding spark plug gap and ignition timing. I have a 308 in my FJ40 and i'm running an electronic dizzy and MSD 'Blaster" coil. My question is, do I stay with the factory settings - as I've heard that because there's more spark you can open up the plug gap a little ???
90' GQ, Dual fuel, 4" lift, 33" Buckshots,rock sliders front locker.
Fiberglass FJ40, 308, 35"mtr, lots of bling
Fiberglass FJ40, 308, 35"mtr, lots of bling
Re: Ignition timing on 308
Timing will depend on the fuel and engine setup, so im not much help with that.
As for plugs open them up to 1mm and see how you go. A good MSD setup should spark across that no probs.
As for plugs open them up to 1mm and see how you go. A good MSD setup should spark across that no probs.
Re: Ignition timing on 308
Most electronic igntion systems you run around the 1.1mm plug gap. from memory 308s in the last of the car by models went up to 1.5mm. I would run around the 1.1mm gap.
Total timing should be between 30/34° depending on your motor.
Total timing should be between 30/34° depending on your motor.
GU 42td wagon for touring
GU ute for the fun stuff
http://www.allterrain4wd.org.au/
GU ute for the fun stuff
http://www.allterrain4wd.org.au/
Re: Ignition timing on 308
Thanks Clanky & Turbo GU for the info. I'm running under 1mm gap & about 5deg before top dead centre at the moment so I'll open it up a bit and see what happens.My main problem has been at low revs in 4th when I get a slight miss. At higher revs I don't notice a problem.
90' GQ, Dual fuel, 4" lift, 33" Buckshots,rock sliders front locker.
Fiberglass FJ40, 308, 35"mtr, lots of bling
Fiberglass FJ40, 308, 35"mtr, lots of bling
Re: Ignition timing on 308
I would be running around 10/12degrees advance. make sure u check it with the vac advance disconnected 5degrees is quite low advance.
GU 42td wagon for touring
GU ute for the fun stuff
http://www.allterrain4wd.org.au/
GU ute for the fun stuff
http://www.allterrain4wd.org.au/
Who is online
Users browsing this forum: No registered users and 155 guests