I am chasing some details and dimensions of a FZJ75 clutch. Its been suggested that it will be suitable for a gearbox conversion in 80 series or 100 series using a H150 behind a 1HD-T.
I am chasing input shaft diameter and spline count.
Also clutch plate diameter? Is it 300mm?
Any info would be great
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
FZJ75 Clutch dimensions?
Moderators: toaddog, Elmo, DUDELUX
Re: FZJ75 Clutch dimensions?
From what my exedy book states, The FZJ75 clutch goes some like this. Clutch disc will be 275mm by 32.4mm wide input shaft, with 14 slines on the input.
I'm about to order a clutch for a bloke who is doing the same sorta thing but putting this setup behind the HZJ79.
Hope it helps sum mate, -Simmo
I'm about to order a clutch for a bloke who is doing the same sorta thing but putting this setup behind the HZJ79.
Hope it helps sum mate, -Simmo
Re: FZJ75 Clutch dimensions?
Thanks Simmo
I had been told it was a 300mm clutch.
Spline count is wrong also.
Cheers.
I had been told it was a 300mm clutch.
Spline count is wrong also.
Cheers.
Who is online
Users browsing this forum: No registered users and 26 guests