At the moment when i go to start my patrol (gq wagon, 93 RX model, 4.2 EFI)
if i turn the key nothing will happen and to get it to start you have turn it back to off then push the key in hard and turn on for it too make contact so it starts.
two questions 1. will the entire ignition switch need to be replaced or just the barrel and 2. is it a hard job as i have never replace either before.
thanks in advance
Lindsay.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Ignition switch Fault
Ignition switch Fault
GQ Patrol wagon, petrol, boat towing vehicle
Re: Ignition switch Fault
Remove plastic steering colume cover, check ignition mounting bolts are tight, also try spraying electrical contact cleaner in the barrel etc.
Had same problem, this fixed it.
Had same problem, this fixed it.
26 PSI 88 SWB TD 42 W/A IC
Re: Ignition switch Fault
cheers thanks for that i will give it a shot tomorro. It would be nice if that was all that was wrong!
GQ Patrol wagon, petrol, boat towing vehicle
Who is online
Users browsing this forum: No registered users and 1 guest